ML145106 Datasheet, PDF (1/8 Pages) LANSDALE Semiconductor Inc. – PLL Frequency Synthesizer CMOS

ML145106
PLL Frequency Synthesizer
CMOS
INTERFACES WITH DUAL–MODULUS PRESCALERS
Legacy Device: Motorola MC145106
The ML145106 is a phase–locked loop (PLL) frequency synthesizer
constructed in CMOS on a single monolithic structure. This synthesizer
finds applications in such areas as AM radio, shortwave, amateur radio,
CB and FM transceivers. The device contains an oscillator/amplifier, a
210 or 211 divider chain for the oscillator signal, a programmable
divider chain for the input signal, and a phase detector. The ML145106
has circuitry for a 10.24 MHz oscillator or may operate with an exter-
nal signal. The circuit provides a 5.12 MHz output signal, which can be
used for frequency tripling. A 2⁹ programmable divider divides the
input signal frequency for channel selection. The inputs to the program-
mable divider are standard ground–to–supply binary signals. Pull–down
resistors on these inputs normally set these inputs to ground enabling
these programmable inputs to be controlled from a mechanical switch
or electronic circuitry.
The phase detector may control a VCO and yields a high level signal
when input frequency is low, and a low level signal when input fre-
quency is high. An out–of–lock signal is provided from the on–chip
lock detector with a “0” level for the out–of–lock condition.
• Single Power Supply
• Wide Supply Range: 4.5 to 12 V
• Provision for 10.24 MHz Crystal Oscillator
• 5.12 MHz Output
• Programmable Division Binary Input Selects up to 2⁹
• On–Chip Pull–Down Resistors on Programmable Divider Inputs
• Selectable Reference Divider, 2¹⁰ or 2¹¹ (Including ÷ 2)
• Three–State Phase Detector
• See Application Note AN535 and Article Reprint AR254
• Chip Complexity: 880 FETs or 220 Equivalent Gates
18
1
P DIP 18 = VP
PLASTIC DIP
CASE 707
20
1
SOG 20W = -6P
SOG PACKAGE
CASE 751D
CROSS REFERENCE/ORDERING INFORMATION
PACKAGE
MOTOROLA
LANSDALE
P DIP 18
SOG 20W
MC145106P ML145106VP
MC145106DW ML145106-6P
Note: Lansdale lead free (Pb) product, as it
becomes available, will be identified by a part
number prefix change from ML to MLE.
OSCout
OSCin
fin
Page 1 of 8
BLOCK DIAGRAM
÷ 2out
÷2
FS
REFERENCE
DIVIDE 29 OR 210
DIVIDE–BY–N COUNTER 29 – 1
PHASE
DETECTOR
φDetout
LD
P0 P1 P2 P3 P4 P5 P6 P7 P8
www.lansdale.com
Issue bCB