KK5851 Datasheet, PDF (3/7 Pages) KODENSHI KOREA CORP. – PULSE DIALER WITH REDIAL

KK5851
RC1-RC3
7,8,9
pin is connected to the common part in general applications.
Oscillator
The KK5851N contains on-chip inverters to provide oscillator which will operate
with a minimum external components.
Following figure shows the on-chip configuration with the necessary external
components. Optimum stability occurs with the ration K=R_S/R equal to 10
The oscillator period is given by:
T=RC(1.386+(3.5KC_S)/C-(2K/(K+1)) in (K/(1.5K + 0.5))
Where C_S is the stray capacitance on Pin 7.
Accuracy and stability will be enhanced with this capacitance minimized.
PPS
M/B
____
Mute
OH
10 10/20pps Select
Connecting this pin to GND (pin 6) will select an output pulse rate of 10pps.
Connecting the pin V_CC (pin 1) will select an output pulse rate of 20pps.
11 Make/break Select
The Make/Break pin controls the Make/Break ratio of the pulse output. The
make/Break ratio is controlled by connection V_CC or GND to this pin as shown in
the following table.
Input
Make
Break
V_CC (Pin1)
33.4%
66.6%
GND(PIn 6) 40%
60%
12 Mute Output
The mute output is an open-drain N-Channel transistor designed to drive external
bipolar transistor.
This circuitry is usually used to mute the receiver during outpulsing. As shown in
Fig. 2 the KK5851N mute output turns on (pulls to the V_GND-supply) at the
beginning of the predigital pause and turns off (goes to an open circuit) following
the last break.
The delay from the end of the last break until the mute output turns off is mute
overlap and is specified as t_MO.
17 ON-HOOK/TEST
This pin detects the state of the hook switch contact “OFF HOOK” corresponds
to V_SS condition. ÖN HOOK”corresponds to V_DD condition. When outpulsing in
this mode, which can be up to 300msec, is completed, the circuit is deactivated
and will require current only necessary to sustain the memory and power-up-clear
detect circuitry (refer to the electrical specifications).
Upon retuning off-hook, a negative transistion on the mute output will insure the
speech network is connected to the line. If the first key entry is either a * or #, the
3