KKX485 Datasheet, PDF (1/6 Pages) KODENSHI KOREA CORP. – Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers

TECHNICAL DATA
Low-Power, Slew-Rate-Limited RS-485/RS-422 _KKX485
Transceivers
General Description
The KKX485 is low-power transceivers for RS-485 and RS-
422 communication. IC contains one driver and one receiver.
The driver slew rates of the KKX485 is not limited, allowing
them to transmit up to 2.5Mbps.
These transceivers draw between 120µA and 500µA of
supply current when unloaded or fully loaded with disabled
drivers. All parts operate from a single 5V supply. Drivers are
short-circuit current limited and are protected against
excessive power dissipation by thermal shutdown circuitry
that places the driver outputs into a high-impedance state.
The receiver input has a fail-safe feature that guarantees a
logic-high output if the input is open circuit. The KKX485 is
designed for half-duplex applications.
ORDERING INFORMATION
KKX485N Plastic
KKX485D SOIC
Features
ƒ Low Quiescent Current: 300µA
ƒ -7V to +12V Common-Mode Input Voltage Range
ƒ Three-State Outputs
ƒ 30ns Propagation Delays, 5ns Skew
ƒ Full-Duplex and Half-Duplex Versions Available
ƒ Operate from a Single 5V Supply
ƒ Allows up to 32 Transceivers on the Bus
ƒ Data rate: 2,5 Mbps
ƒ Current-Limiting and Thermal Shutdown for Driver Overload Protection
1