GS1DC106 Datasheet, PDF (3/3 Pages) KOA Speer Electronics, Inc. – high voltage high resistance thick film resistors

GS
high voltage high resistance thick film resistors
environmental applications
Performance Characteristics
Parameter
Resistance
T.C.R.
Overload (Short time)
Resistance to Solder Heat
Rapid Change of Temperature
Moisture Resistance
Endurance @ 25°C
Voltage Coefficient
Voltage Characteristics
Resistance tp Solvent
Impulse Withstand Voltage
Requirement ∆ R ±%
Within regulated tolerance
Within specified T.C.R.
2: TCR 200x10^-6/K
0.5: TCR 100x10^-6/K
2: TCR 200x10^-6/K
0.5: TCR 100x10^-6/K
2: TCR 200x10^-6/K
0.5: TCR 100x10^-6/K
5: TCR 200x10^-6/K
2: TCR 100x10^-6/K
3: TCR 200x10^-6/K
2: TCR 100x10^-6/K
±50x10^-6/V: TCR 200x10^-6/K
±10x10^-6/V: TCR 100x10^-6/K
5: TCR 200x10^-6/K
3: TCR 100x10^-6/K
No evidence of damage to protective
coating and marking
No abnormality in appearance
and flash-over
25°C
Test Method
+25°C/125°C
Rated voltage x 2.5 (GS1/4, GS1/2), rated voltage x 2 (GS1-GS12)
or Max. overload voltage, whichever is lower for 5 seconds
350°C ± 10°C, 3 seconds ± 0.5 seconds or 260°C ± 5°C,
10 seconds ± 1 second
-55°C (30 minutes)/ +125°C (30 minutes), 5 cycles
40°C, 90% - 95%RH, 1000h
25°C, 1000 hours
1.5 hr ON/0.5 hr OFF cycle
GS1/4, 1/2 only, Rated voltage or max. working voltage,
whichever is lower and 1/10 of its voltage
GS1 - 12, Rated voltage or max. working voltage,
whichever is lower and 1/10 of its voltage
Soaking in IPA for 1 minute and brushing 10 times -3 cycles -
liquid temperature 25°C ±5°C
An impulse voltage shall be applied 5 times at an interval of 1 minute
118
Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use.
1/02/06
KOA Speer Electronics, Inc. • 199 Bolivar Drive • Bradford, PA 16701 • USA • 814-362-5536 • Fax: [phone] • www.koaspeer.com