CN1H2N Datasheet, PDF (3/4 Pages) KOA Speer Electronics, Inc. – Flat Chip Resistor Array

KOA SPEER ELECTRONICS, INC.
SS-242 R7
5.1 Voltage Rating
Resistors shall have a rated direct current (DC)
continuous working voltage or an approximate
sine wave root mean square (RMS) alternating
current (AC) continuous working voltage at
a commercial line frequency and wave form
corresponding to the power rating, as determined
from the following formula:
In no case shall the rated DC or RMS AC
continuous working voltage be greater
than the applicable maximum value.
Where, E = Rated voltage (V)
E =√ P x R
P = Power rating (W)
R = Nominal resistance (Ω)
6. Characteristics
Item
Temperature
Coefficient
Short-time
Overload
Resistance to
Soldering Heat
Solderability
Temperature
Cycling
Requirement
Within specified limits
±(2.0% +0.1Ω)
No visual damage
±(1.0% +0.1Ω)
More than 75% of the surface of electrode
shall be covered with new solder
±(1.0% +0.1Ω)
No mechanical damage
Heat
Resistance
Endurance
(Moisture Load)
Endurance
(Rated Load)
±(1.0% +0.1Ω)
±(5.0% +0.1Ω)
±(5.0% +0.1Ω)
Test Method
JIS C 5202 5.2B
-55°C ~ +125°C
JIS C 5202 5.5A
Rated voltage x 2.5
JIS C 5202 6.4
260°C ± 5°C 10 sec. ± 1 sec.
JIS C 5202 6.5
230°C ± 5°C 2 sec. ± 0.5 sec.
JIS C 5202 7.4
5 cycles of the change in temp. given
in the following steps
Step 1: -55°C ± 3°C / 30 minutes
Step 2: Normal temp. 10 min. to 15 min.
Step 3: +125°C ± 3°C / 30 minutes
Step 4: Normal temp. 10 min. to 15 min.
JIS C 5202 7.2
125°C ± 2°C 1000 Hr
JIS C 5202 7.9
40°C ± 2°C / 90 ~ 95% RH
rated
voltage
1000
Hr
±
4.8
0
Hr
JIS C 5202 7.10
70°C ± 2°C
rated voltage 1000 Hr ± ^40.8Hr
PAGE 3 OF 4
Bolivar Drive ^I P.O. Box 547 ^I Bradford, PA 16701 ^I USA ^I 814-362-5536 ^I Fax [phone] ^I www.koaspeer.com
Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use.