CFS14C852R103J Datasheet, PDF (2/2 Pages) KOA Speer Electronics, Inc. – carbon film leaded resistors

CF
carbon film leaded resistors
applications and ratings
Part
Designation
Power
Rating
@ 70°C
Minimum
Dielectric
Withstanding
Voltage
+350 to -450
T.C.R.
(ppm/°C)
0 to -700 0 to -1000
0 to -1300
Resistance Resistance
Range
Range
E-24
E-24
(G±2%)
(J±5%)
Absolute
Maximum
Working
Voltage
CFS1/4
CFPS1/4
CF1/4
CFP1/4
CFS1/2
CFPS1/2
0.25W
0.50W
300V
500V
700V
10Ω - 330kΩ 2.2Ω - 1MΩ
2.2Ω - 47kΩ 51kΩ - 100kΩ 110kΩ - 330kΩ 360kΩ - 1MΩ
10Ω - 100kΩ 2.2Ω - 1MΩ
1.1MΩ - 5.1MΩ
2.2Ω - 100kΩ 110kΩ - 330kΩ 360kΩ - 1MΩ
—
1.0Ω - 91kΩ
1.1MΩ - 2.2MΩ 2.4MΩ - 5.1MΩ
100kΩ - 1MΩ
2.2Ω - 91kΩ
—
—
10Ω - 1MΩ
2.2Ω - 5.1MΩ
2.2Ω - 1MΩ
1.0Ω - 5.1MΩ
2.2Ω - 1MΩ
250V
300V
350V
Absolute
Maximum
Overload
Voltage
500V
600V
700V
environmental applications
Derating Curve
Surface Temperature Rise
100
60
80
50
40
CFS1/2
60
CFB1/2
30
CFPS1/4
40
CFS1/4
20
20
10
0
0
-60 -40 -20 0 20 40 60 80 100 120 140 160
0
-55
70
155
Ambient Temperature
(°C)
For resistors operated at an ambient temperature
of 70°C or above, a power rating shall be derated
in accordance with the above derating curve.
25
50
75
100
% Rated Power
Load Life @ 70°C, 1000 Hr
+2
CFS1/4
+1
0
-1
-2
10
100
1k
10k
100k
1M
Resistance
(Ω)
Performance Characteristics
Parameter
Requirement ∆ R ±(% + 0.05Ω)
Limit
Typical
Resistance
Within specified
tolerance
—
T.C.R.
Within specified
T.C.R.
—
Overload (Short time)
±1%
±0.5%
Resistance to Solder Heat
Terminal Strength
±1%
No lead-coming off
and loose terminals
±0.5%
—
Rapid Change of Temperature
Moisture Resistance
Endurance at 70°C
±1%
±5%
±3%
±0.5%
±2.5%
±1.5%
Resistance to Solvent
(CFS & CFPS only)
No abnormality
in appearance.
Marking shall be
––
easily legible.
Flame Retardant
(CFS & CFPS only)
No evidence
of flaming or
––
self-flaming
Test Method
Measuring points are at 10mm ±1mm from the end cap.
Room temperature +100°C
Rated voltage x 2.5 or max. overload voltage for 5 seconds, whichever is lower
260°C ±5°C, 10 seconds ± 1 second
Twist 360°C, 5 times
-55°C (30 minutes), +125°C (30 minutes), 5 cycles
40°C ± 2°C, 90 - 95% RH, 1000 hours, 1.5 hr ON, 0.5 hr OFF cycle
70°C ± 2°C, 1000 hours, 1.5 hr ON, 0.5 hr OFF cycle
Ultrasonic washing with Isopropyl alcohol for 2 minutes.
Power: 0.3W/cm², f: 28kHz, temp: 35°C±5°C
Flame test: The test flame shall be applied and removed for each 15 seconds
respectively to repeat the cycle 5 times.
Overload flame retardant: Power (AC) corresponding to 2, 4, 8, 16 and 32
times the power rating shall be applied for each 1 minute until disconnection
occurs. However the applied voltage shall not exceed 4 times the maximum
operating voltage.
108
Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use.
12/18/12
KOA Speer Electronics, Inc. • 199 Bolivar Drive • Bradford, PA 16701 • USA • 814-362-5536 • Fax: [phone] • www.koaspeer.com