MB2S-MB10S Datasheet, PDF (1/2 Pages) Kingtronics International Company – Single Phase 0.8 AMPS. Glass Passivated Bridge Rectifiers Voltage Range 200 to 1000 Volts Current 0.8 Amperes

Website: www.kingtronics.com Email: [e-mail] Tel: [phone] Fax: [phone]
MB2S THRU MB10S
Single Phase 0.8 AMPS. Glass Passivated Bridge Rectifiers
Voltage Range 200 to 1000 Volts Current 0.8 Amperes
FEATURES
◆Ideal for printed circuit board
◆Reliable low cost construction technique
results in inexpensive product
◆High temperature soldering guaranteed:
260℃ / 10 seconds / 0.375” ( 9.5mm )
lead length at 5 lbs., ( 2.3 kg ) tension
◆UL Recognized File number: E347214
MECHANICAL DATA
◆Case: Molded plastic
◆Lead: solder plated
◆Polarity: As marked
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating at 25℃ ambient temperature unless otherwise specified.
Single phase, half wave, 60Hz, resistive or inductive load.For capacitive load, derate current by 20%
SYMBOLS MB2S MB4S MB6S MB8S MB10S UNITS
Maximum Repetitive Peak Reverse Voltage
Maximum RMS Voltage
Maximum DC Blocking Voltage
VRRM
VRMS
VDC
200
400
600
800
1000
140
280
420
560
700
200
400
600
800
1000
Maximum Average Forward Rectified Current
0.5
On glass-epoxy P.C.B.
I(AV)
0.8
On aluminum substrate
Peak Forward Surge Current,
8.3ms Single Half Sine-wave Superimposed on
IFSM
35
Rated Load (JEDEC method )
Maximum Instantaneous Forward Voltage at 0.4A
VF
Maximum DC Reverse Current @ TA=25℃
IR
Rated DC Blocking voltage per leg TA=125℃
1.0
5.0
500
Typical Thermal Resistance (Note1)
RθJA
70
(Note2)
RθJL
20
Operating Temperature Range
TJ
-55 to +150
Storage Temperature Range
TSTG
-55 to +150
Note: 1.On aluminum suvstrate P.C.B. with an area of 0.8×0.8”(20×20mm) mounted on 0.05×0.05”(1.3×1.3mm) solder pad.
2. Thermal Resistance from Junction to Case with units Mounted on 2.6×1.4×0.06”Thick(6.5×3.5×0.15cm)Al.Plate.
V
V
V
A
A
V
μA
℃/W
℃
℃
1