KB816 Datasheet, PDF (6/9 Pages) Kingbright Corporation – PHOTOCOUPLER

PHOTOCOUPLER
Part Number: KB816
Fig. 11 Collector-emitter Saturation
Voltage vs. Forward Current
*NOTES ON HANDLING
1.Recommended soldering conditions (Dip soldering)
(1) Dip soldering
Temperature
Time
Cycle
Flux
260 °C or below (molten solder temperature)
Less than 10 seconds.
One cycle allowed to be dipped in solder including plastic mold portion.
Rosin flux containing small amount of chorine
(The flux with a maximum chlorine content of 0.2 Wt % is recommended.)
(2) Cautions
Fluxes
Avovid removing the residual flux with freon-based and chlorine-based cleaning solvent.
2.Cautions regarding noise
Be aware that power is suddenly into the componment any surge current may cause damage happen,
even if the voltage is within the absolute maximum ratings.
SPEC NO: DSAD1545
APPROVED: J. Lu
REV NO: V.8
CHECKED: Tracy Deng
DATE: FEB/26/2007
DRAWN: Y.W.WANG
PAGE: 6 OF 9
ERP: 1205000005