WP7113VW1C Datasheet, PDF (2/7 Pages) Kingbright Corporation – T-1 3/4 (5mm) SOLID STATE LAMP

Selection Guide
Part No.
Emitting Color (Material)
Lens Type
WP7113VW1C
White (InGaN)
Water Clear
Notes:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2. Luminous intensity / luminous Flux: +/-15%.
3. Luminous intensity value is traceable to CIE127-2007 standards.
Iv (mcd) [2]
@ 20mA
Viewing
Angle [1]
Min. Typ. 2θ1/2
7000 10000
20°
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Emitting Color
Typ.
Max.
Units Test Conditions
VF [1]
Forward Voltage
White
3.3
4.0
V
IF=20mA
IR
Reverse Current
White
50
uA
VR = 5V
X [2]
0.31
Chromaticity Coordinates
White
Y [2]
0.31
C
Capacitance
White
100
pF
VF=0V;f=1MHz
Notes:
1. Forward Voltage: +/-0.1V.
2. Measurement tolerance of the chromaticity coordinates is ±0.02.
3. Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Absolute Maximum Ratings at TA=25°C
Parameter
Values
Power dissipation
120
DC Forward Current
30
Peak Forward Current [1]
100
Reverse Voltage
5
Electrostatic Discharge Threshold (HBM)
250
Operating/Storage Temperature
-40°C To +85°C
Lead Solder Temperature [2]
260°C For 3 Seconds
Lead Solder Temperature [3]
260°C For 5 Seconds
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 2mm below package base.
3. 5mm below package base.
4. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static
electricity – Ref JEDEC/JESD625-A and JEDEC/J-STD-033.
Units
mW
mA
mA
V
V
SPEC NO: DSAJ9217
APPROVED: Wynec
REV NO: V.5B
CHECKED: Allen Liu
DATE: SEP/07/2016
DRAWN: L.T.Zhang
PAGE: 2 OF 7
ERP: 1101026690