WP7113LVBC-D Datasheet, PDF (2/6 Pages) Kingbright Corporation – T-1 3/4 (5mm) SOLID STATE LAMP

Selection Guide
Part No.
Emitting Color (Material)
Lens Type
WP7113LVBC/D
Blue (InGaN)
Water Clear
Notes:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2. Luminous intensity / luminous Flux: +/-15%.
3. Luminous intensity value is traceable to CIE127-2007 standards.
Iv (mcd) [2]
@ 2mA
Min. Typ.
550 1600
Viewing
Angle [1]
2θ1/2
20°
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Emitting Color Min. Typ. Max.
Units
Test Conditions
λpeak
λD [1]
Peak Wavelength
Dominant Wavelength
Blue
Blue
465
nm
IF=2mA
470
nm
IF=2mA
Δλ1/2
Spectral Line Half-width
Blue
22
nm
IF=2mA
C
Capacitance
Blue
100
pF
VF=0V;f=1MHz
VF [2]
IR
Forward Voltage
Reverse Current
Blue
Blue
2.2
2.65
3.0
V
50
uA
IF=2mA
VR = 5V
Notes:
1. Wavelength: +/-1nm.
2. Forward Voltage: +/-0.1V.
3. Wavelength value is traceable to CIE127-2007 standards.
4. Excess driving current and / or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Absolute Maximum Ratings at TA=25°C
Parameter
Power dissipation
DC Forward Current
Values
90
30
Peak Forward Current [1]
100
Electrostatic Discharge Threshold (HBM)
250
Reverse Voltage
5
Operating/Storage Temperature
-40°C To +85°C
Lead Solder Temperature [2]
260°C For 3 Seconds
Lead Solder Temperature [3]
260°C For 5 Seconds
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 2mm below package base.
3. 5mm below package base.
4. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static
electricity – Ref JEDEC/JESD625-A and JEDEC/J-STD-033.
Units
mW
mA
mA
V
V
SPEC NO: DSAN8290
APPROVED: Wynec
REV NO: V.3B
CHECKED: Allen Liu
DATE: JUL/01/2016
DRAWN: W.Q.Zhong
PAGE: 2 OF 6
ERP: 1101033258