WP710A10SEC_15 Datasheet, PDF (2/6 Pages) Kingbright Corporation – T-1(3mm) SOLID STATE LAMP

Selection Guide
Part No.
Dice
Lens Type
WP710A10SEC
Super Bright Orange (AlGaInP)
Water Clear
Notes:
1.θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2.Luminous intensity/ luminous Flux: +/-15%.
*Luminous intensity value is traceable to the CIE127-2007 compliant national standards.
Iv (mcd) [2]
@ 20mA
Min. Typ.
900 1700
*350 *800
Viewing
Angle [1]
2θ1/2
34°
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Device
Typ.
Max.
Units Test Conditions
λpeak
Peak Wavelength
Super Bright Orange
610
nm
IF=20mA
λD [1]
Dominant Wavelength
Super Bright Orange
601
nm
IF=20mA
Δλ1/2
Spectral Line Half-width
Super Bright Orange
29
nm
IF=20mA
C
Capacitance
Super Bright Orange
30
pF
VF=0V;f=1MHz
VF [2]
Forward Voltage
Super Bright Orange
2.0
2.5
V
IF=20mA
IR
Reverse Current
Super Bright Orange
10
uA
VR = 5V
Notes:
1.Wavelength: +/-1nm.
2.Forward Voltage: +/-0.1V.
3.Wavelength value is traceable to the CIE127-2007 compliant national standards.
4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Absolute Maximum Ratings at TA=25°C
Parameter
Power dissipation
DC Forward Current
Peak Forward Current [1]
Reverse Voltage
Operating/Storage Temperature
Lead Solder Temperature [2]
Lead Solder Temperature [3]
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 2mm below package base.
3. 5mm below package base.
Super Bright Orange
75
30
195
5
-40°C To +85°C
260°C For 3 Seconds
260°C For 5 Seconds
SPEC NO: DSAL0514
APPROVED: WYNEC
REV NO: V.4A
CHECKED: Allen Liu
DATE: JAN/17/2015
DRAWN: Q.M.Chen
Units
mW
mA
mA
V
PAGE: 2 OF 6
ERP: 1101028999