WP36BID_15 Datasheet, PDF (2/6 Pages) Kingbright Corporation – T-1 (3mm) BLINKING LED LAMP

Selection Guide
Part No.
Dice
Lens Type
WP36BID
High Efficiency Red (GaAsP/GaP)
Red Diffused
Note:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
* Luminous intensity value is traceable to the CIE127-2007 compliant national standards.
Iv (mcd)
V= 9V
Min. Typ.
12
25
*6
*15
Viewing
Angle [1]
2θ1/2
60°
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Device
Min.
Typ. Max. Units Test Conditions
λpeak
Peak Wavelength
High Efficiency Red
627
nm
λD
Dominant Wavelength High Efficiency Red
617
nm
Δλ1/2 Spectral Line Half-width High Efficiency Red
45
nm
IF
Forward Current
High Efficiency Red
8
22
mA
Min:VF=3.5V
Typ:VF=5V
ISON
Supply Current
High Efficiency Red
8
mA
VF=3.5V
ISON
Supply Current
High Efficiency Red
44
mA
VF=14V
f
Blink Frequency
High Efficiency Red
1.5
3
Hz
VF=3.5V~14V
Notes:
1.Wavelength value is traceable to the CIE127-2007 compliant national standards.
2.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Absolute Maximum Ratings at TA=25°C
Parameter
Power dissipation
Forward Voltage
Reverse Voltage
Operating Temperature
Storage Temperature
Lead Solder Temperature [1]
Lead Solder Temperature [2]
Notes:
1. 2mm below package base.
2. 5mm below package base.
High Efficiency Red
310
14
0.5
-40°C To +70°C
-40°C To +85°C
260°C For 3 Seconds
260°C For 5 Seconds
SPEC NO: DSAF2213
APPROVED: WYNEC
REV NO: V.8A
CHECKED: Allen Liu
DATE: JAN/26/2015
DRAWN: P.Cheng
Units
mW
V
V
PAGE: 2 OF 6
ERP: 1101003774