APT2012ZGC_15 Datasheet, PDF (2/5 Pages) Kingbright Corporation – 2.0x1.25mm SMD CHIP LED LAMP

Selection Guide
Part No.
Dice
Lens Type
APT2012ZGC
Green (InGaN)
Water Clear
Notes:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2. Luminous intensity/ luminous Flux: +/-15%.
3. Luminous intensity value is traceable to the CIE127-2007 compliant national standards.
Iv (mcd) [2]
@ 20mA
Min. Typ.
200 400
Viewing
Angle [1]
2θ1/2
120°
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Device
Min.
Typ.
Max.
Units Test Conditions
λpeak
Peak Wavelength
Green
515
nm
IF=20mA
λD [1]
Dominant Wavelength
Green
525
nm
IF=20mA
Δλ1/2
Spectral Line Half-width
Green
30
nm
IF=20mA
C
Capacitance
Green
45
pF
VF=0V;f=1MHz
VF [2]
Forward Voltage
Green
2.7
3.3
4.1
V
IF=20mA
IR
Reverse Current
Green
50
uA
VR=5V
Notes:
1.Wavelength: +/-1nm.
2.Forward Voltage: +/-0.1V.
3.Wavelength value is traceable to the CIE127-2007 compliant national standards.
4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Absolute Maximum Ratings at TA=25°C
Parameter
Power dissipation
DC Forward Current
Peak Forward Current [1]
Reverse Voltage
Operating Temperature
Storage Temperature
Note:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
Green
102.5
25
150
5
-40°C To +85°C
-40°C To +85°C
SPEC NO: DSAE3711
APPROVED: WYNEC
REV NO: V.10B
CHECKED: Allen Liu
DATE: FEB/04/2015
DRAWN: P.Cheng
Units
mW
mA
mA
V
PAGE: 2 OF 5
ERP: 1203003552