APT2012LSECK-J3-PRV Datasheet, PDF (2/5 Pages) Kingbright Corporation – Low power consumption

Selection Guide
Part No.
Dice
Lens Type
APT2012LSECK/J3-PRV
Hyper Red (AlGaInP)
Water Clear
Notes:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2. Luminous intensity/ luminous Flux: +/-15%.
*Luminous intensity value is traceable to the CIE127-2007 compliant national standards.
Iv (mcd) [2]
@ 2mA
Min. Typ.
50
100
*20
*40
Viewing
Angle [1]
2θ1/2
120°
Electrical / Optical Characteristics at TA=25°C
Symbol
Parameter
Device
Min.
Typ. Max. Units Test Conditions
λpeak
Peak Wavelength
Hyper Red
640
nm
IF=2mA
λD [1]
Dominant Wavelength
Hyper Red
625
nm
IF=2mA
Δλ1/2
Spectral Line Half-width
Hyper Red
20
nm
IF=2mA
C
Capacitance
Hyper Red
27
pF
VF=0V;f=1MHz
VF [2]
Forward Voltage
Hyper Red
1.5
1.8
2.1
V
IF=2mA
IR
Reverse Current
Hyper Red
10
uA
VR=5V
Notes:
1.Wavelength: +/-1nm.
2.Forward Voltage: +/-0.1V.
3.Wavelength value is traceable to the CIE127-2007 compliant national standards.
4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Absolute Maximum Ratings at TA=25°C
Parameter
Power dissipation
DC Forward Current
Peak Forward Current [1]
Reverse Voltage
Operating Temperature
Storage Temperature
Note:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
Hyper Red
63
30
150
5
-40°C To +85°C
-40°C To +85°C
Units
mW
mA
mA
V
SPEC NO: DSAN8393
APPROVED: WYNEC
REV NO: V.2A
CHECKED: Allen Liu
DATE: MAR/09/2015
DRAWN: P.Cheng
PAGE: 2 OF 5
ERP: 1203014460