N9040B Datasheet, PDF (18/29 Pages) Keysight Technologies – UXA X-Series Signal Analyzer, Multi-touch N9040B

18 | Keysight | N9040B UXA X-Series Signal Analyzer, Multi-touch - Data Sheet
Inputs and Outputs (continued)
Noise source drive +28 V (pulsed)
Connector
Output voltage
BNC female
On 28.0 ± 0.1 V (60 mA maximum)
Off < 1 V
SNS series noise source
For use with the Agilent/Keysight SNS Series noise sources
Digital bus
Connector
MDR-80
Analog out
Connector
BNC female
USB ports
Master (3 ports)
Standard
Connector
Output current
Slave (1 port)
Standard
Connector
Two ports (stacked with each other) are compatible with USB 3.0; one (stacked with LAN port) with USB 2.0
USB Type-A female
0.5 A nominal
Compatible with USB 3.0
USB Type-B female
GPIB interface
Connector
GPIB codes
GPIB mode
IEEE-488 bus connector
SH1, AH1, T6, SR1, RL1, PP0, DC1, C1, C2, C3, C28, DT1, L4, C0
Controller or device
LAN TCP/IP interface
Standard
Connector
1000Base-T
RJ45 Ethertwist
IF output
Connector
Impedance
SMA female, shared by the second IF out (wideband, standard) and Opt CRP, and ALV
50 Ω nominal
2nd IF output
Center frequency
SA mode or I/Q analyzer with IF BW ≤ 25 MHz 322.5 MHz
with Option B40
250 MHz
with Option B2X
750 MHz
with Option B5X
877.1484375 MHz
Conversion gain
1 dB nominal
Bandwidth
Low band
IF Path ≤ 40 MHz
Up to 160 MHz nominal
IF Path 255 MHz
255 MHz nominal
IF Path 510 MHz
510 MHz nominal
IF Path 1 GHz
1 GHz nominal
High band, with preselector bypassed
Up to 800 MHz (nominal); expandable to 1200 MHz with corrections
IF2 output for 1 GHz analog IF
Connector
Impedance
Center frequency
SMA female
50 Ω nominal
750 MHz
IF2 input for 1 GHz digital section
Connector
Impedance
Center frequency
SMA female
50 Ω nominal
750 MHz
Trigger 3 input for 1 GHz digitizer
Connector
Impedance
Trigger level range
Trigger channel passband
BNC female
50 Ω, DC terminated
± 5 V range (minimum amplitude 0.5 V pk-pk)
DC to 2 GHz nominal