MIL-C-11015 Datasheet, PDF (8/10 Pages) Cornell Dubilier Electronics – Multilayer Ceramic Capacitors

CERAMIC LEADED
PACKAGING INFORMATION
Ceramic Axial
Lead Tape and Reel Packaging
KEMET offers standard reeling of Molded and Conformally
Coated Axial Leaded Ceramic Capacitors for automatic insertion
or lead forming machines per EIA specification RS-296. KEMET’S
internal specification four-digit suffix, 7200, is placed at the end of
the part number to designate tape and reel packaging, ie:
C410C104Z5U5CA7200.
Paper (50 lb.) test minimum is inserted between the layers of
capacitors wound on reels for component pitch ≤ 0.400".
Capacitor lead length may extend only a maximum of .0625"
(1.59mm) beyond the tapes' edges. Capacitors are centered in a
row between the two tapes and will deviate only ± 0.031
(0.79mm) from the row center. A minimum of 36" (91.5 cm) leader
tape is provided at each end of the reel capacitors. Universal
splicing clips are used to connect the tape. Standard reel
quantities are shown on page 41.
Adhesive Tape
Figure 1
KEMET ^®
KEMET ^®
Adhesive Tape
Kraft Paper
Interleaving
Figure 2
10.5" - 14"
.059" to .315"
(26.67 -
35.56cm)
*
Greater Than
Component
Length
Figure 3
.047" Max
Hub
(1.20)
Table 1
.655" ±0.010"
(16.6 ±0.25)
3¹/₄"
(82.6)
1/8"
(3.18)
See Table 1
(B)
Dimensions in Inches & (Millimeters)
* ^{See Table 1 (A)}
.250" Nom.
(6.35)
Component
Body Diameter
Component
Pitch "A"
0.020" or (±0.5mm)
Inside Tape Spacing "B"
± 1.5mm (0.059")
I
III*
0" (0mm) to 0.197" (5mm)
0.197" (5.01mm) to 0.394: (10mm)
0.197" or (5mm)
0.394" or (10mm)
2.062" (52.4mm)
2.874" (73mm)
* Not Available for Conformally Coated Parts.
© KEMET Electronics Corporation, P.O. Box 5928, Greenville, S.C. 29606, [phone]
39