FY0H104ZF Datasheet, PDF (5/14 Pages) Kemet Corporation – Supercapacitors FY Series

Supercapacitors – FY Series
Specifications
Item
Category Temperature Range
Maximum Operating Voltage
Capacitance
Capacitance Allowance
ESR
Current (30 minutes value)
Capacitance
Surge
ESR
Current (30 minutes value)
Appearance
Characteristics in Different
Temperature
Lead Strength (tensile)
Vibration Resistance
Capacitance
ESR
Capacitance
ESR
Capacitance
ESR
Current (30 minutes value)
Capacitance
ESR
Current (30 minutes value)
Capacitance
ESR
Current (30 minutes value)
Appearance
Solderability
Solder Heat Resistance
Capacitance
ESR
Current (30 minutes value)
Appearance
FY Type (FYD, FYH, FYL)
-25ºC to +70ºC
5.5 VDC
Refer to Table 1
+80%, -20%
Refer to Table 1
Refer to Table 1
> 90% of initial ratings
≤ 120% of initial ratings
≤ 120% of initial ratings
No obvious abnormality
Test Conditions
(conforming to JIS C 5160-1)
Refer to “Measurement Conditions”
Refer to “Measurement Conditions”
Measured at 1 kHz, 10 mA; See also
“Measurement Conditions”
Refer to “Measurement Conditions”
Surge voltage:
Charge:
Discharge:
Number of cycles:
Series resistance:
Discharge
resistance:
Temperature:
6.3 V
30 seconds
9 minutes 30 seconds
1,000
0.010 F
1500 Ω
0.022 F
560 Ω
0.047 F
300 Ω
0.068 F
240 Ω
0.10 F
150 Ω
0.22 F
56 Ω
0.47 F
30 Ω
1.0 F, 1.4 F
15 Ω
2.2 F
10 Ω
0Ω
70 ±2ºC
Phase 2
≥ 50% of initial value
≤ 400% of initial value
Phase 3
Phase 5
Phase 6
No terminal damage
≤ 200% of initial value
Satisfy initial ratings
≤ 1.5 CV (mA)
Within ±20% of initial value
Satisfy initial ratings
Satisfy initial ratings
Satisfy initial ratings
Conforms to 4.17
Phase 1:
Phase 2:
Phase 4:
Phase 5:
Phase 6:
+25 ±2ºC
-25 ±2ºC
+25 ±2ºC
+70 ±2ºC
+25 ±2ºC
Conforms to 4.9
Conforms to 4.13
Frequency:
Testing Time:
10 to 55 Hz
6 hours
No obvious abnormality
Over 3/4 of the terminal should be covered by the new solder
Satisfy initial ratings
Conforms to 4.11
Solder temp: +245 ±5ºC
Dipping time: 5 ±0.5 seconds
1.6 mm from the bottom should be dipped.
Conforms to 4.10
Solder temp: +260 ±10ºC
Dipping time: 10 ±1 seconds
No obvious abnormality
1.6 mm from the bottom should be dipped.
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 [phone] • www.kemet.com
S6015_FY • 3/7/2014 5