CA064X104K4RACTU Datasheet, PDF (5/20 Pages) Kemet Corporation – Capacitor Array, X7R Dielectric, 10 - 200 VDC (Commercial & Automotive Grade)

Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)
Capacitor Array, X7R Dielectric, 10 – 200 VDC (Commercial & Automotive Grade)
Electrical Parameters/Characteristics
Item
Parameters/Characteristics
Operating Temperature Range
Capacitance Change with Reference to
+25°C and 0 Vdc Applied (TCC)
1_{Aging Rate (Maximum % Capacitance Loss/Decade Hour)}
2_{Dielectric Withstanding Voltage (DWV)}
3_{Dissipation Factor (DF) Maximum Limit at 25°C}
4_{Insulation Resistance (IR) Minimum Limit at 25°C}
−55°C to +125°C
±15%
3.0%
250% of rated voltage
(5±1 seconds and charge/discharge not exceeding 50mA)
See Dissipation Factor Limit Table
1,000 megohm microfarads or 100GΩ
(Rated voltage applied for 120±5 seconds at 25°C)
1 _{Regarding Aging Rate: Capacitance measurements (including tolerance) are indexed to a referee time of 1,000 hours.}
2 _{DWV is the voltage a capacitor can withstand (survive) for a short period of time. It exceeds the nominal and continuous working voltage of the}
capacitor.
3 _{Capacitance and dissipation factor (DF) measured under the following conditions:}
1kHz ± 50Hz and 1.0 ± 0.2 Vrms if capacitance ≤10µF
120Hz ± 10Hz and 0.5 ± 0.1 Vrms if capacitance >10µF
4 _{To obtain IR limit, divide MΩ-µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.}
Note: When measuring capacitance it is important to ensure the set voltage level is held constant. The HP4284 & Agilent E4980 have a feature known as
Automatic Level Control (ALC). The ALC feature should be switched to "ON".
Post Environmental Limits
Dielectric
X7R
High Temperature Life, Biased Humidity, Moisture Resistance
Rated DC
Voltage
Capacitance Dissipation Factor Capacitance
Value
(Maximum %)
Shift
< 16
All
7.5
Insulation
Resistance
16/25
All
5.0
≤ 0.02 µF
3.0
50
> 0.02 µF
5.0
± 20%
10% of
Initial Limit
> 50
All
3.0
Dissipation Factor Limit Table
Rated
DC Voltage
< 16
16/25
50
> 50
Capacitance
All
All
≤ 0.022 µF
> 0.022 µF
All
Dissipation Factor
(Maximum %)
5.0
3.5
2.5
3.5
2.5
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 • 864-963-6300 • www.kemet.com
C1017_X7R_ARRAY_SMD • 10/14/2016 5