C0603C2759PAC Datasheet, PDF (2/2 Pages) Kemet Corporation – Surface Mount Ceramic Chip Capacitors X5R Dielectric

Electrical Parameters
As detailed in the KEMET Surface Mount Catalog F3102 for X5R, with following specific
requirements based on room temperature (25°C) parameters:
• Operating Range: -55°C to +85°C, with no-bias capacitance shift limited to ± 15% over that range
• Insulation Resistance (IR) measured after 2 minutes at rated voltage @ 25°C: Limit is 500
megohm microfarads or 100 gigohms, whichever is less.
• Capacitance and Dissipation Factor (DF) measured at the following conditions. DF Limit is 10%.
1 kHz and 1 Vrms if capacitance ≤ 10 µF
120 Hz and 0.5 Vrms if capacitance > 10 µF
Soldering Process
The 0603 components are suitable for reflow or wave soldering. All parts incorporate the stan-
dard KEMET barrier layer of pure nickel, with an overplate of pure tin to provide excellent solder-
ability as well as resistance to leaching.
Marking
These chips are normally supplied unmarked. If required, they can be laser marked as an extra
cost option. More detail on the marking format is included in our Surface Mount Catalog F3102.
In general, the information in the KEMET Surface Mount catalog F3102 applies to these
capacitors. The information in this bulletin supplements that in the catalog.
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 • [phone] • www.kemet.com