HE84760 Datasheet, PDF (16/31 Pages) King blillion Electronics Co.,Ltd. – 8-bit Micro-controller

King Billion Electronics Co., Ltd
駿億電子股份有限公司
SXI
SXI
HE84760
HE80000 SERIES
SXO
SXO
Crystal Osc.
RC Osc.
With two clock sources available, the system can switch among operation modes of Fast, Slow, Idle, and
Sleep modes by the setting of OP1 and OP2 registers as shown in tables below to suit the needs of
application such as power saving, etc.
OP1
Field
Mode
Reset
Bit 7
DRDY
R/W
1
Bit 6
STOP
R/W
0
Bit 5
SLOW
R/W
0
Bit 4
INTE
R/W
0
Bit 3
T2E
R/W
0
Bit 2
T1E
R/W
0
Bit 1
Z
R/W
-
Bit 0
C
R/W
-
OP2
Field
Mode
Reset
Bit 7
IDLE
R/W
0
Bit 6
PNWK
R
-
Bit 5
TCWK
R
-
Bit 4
TBE
R/W
0
Bit 3
W
-
Bit 2 Bit 1
TBS[3..0]
W
W
-
-
Bit 0
W
-
If the dual clock mode is used, the LCD display, Timer1 and Timer Base will derive its clock source from
slow clock while the other blocks will operate with the fast clock.
9. General Purpose I/O
There are three dedicated general purpose I/O port, PRTC[4..7], PRTD and PRT10[0..3], while PRT14,
PRT15 and PRT17 are multiplexed with LCD segment driver pins. All the I/O Ports are bi-directional and
of non- tri-state output structure. The output has weak sourcing (50 µA) and stronger sinking (1 mA)
capability and each can be configured as push-pull or open-drain output structure individually by mask
option.
When the I/O port is used as input, the weakly high sourcing can be used as weakly pull-up. Open drain
can be used if the pull-up is not required and let the external driver to drive the pin. Please note that a
floating pad could cause more power consumption since the noise could interfere with the circuit and
cause the input to toggle. A ‘1’ needs to be written to port first before reading the input data from the I/O
pin. If the PMOS is used as pull-up, care should be taken to avoid the constant power drain by DC path
between pull-up and external circuit.
The input port has built-in Schmidt trigger to prevent it from chattering. Hysteresis level of Schmidt
trigger is 1/3*VDD.
August 15, 2003
Page 16 of 31
V1.2
This specification is subject to change without notice. Please contact sales person for the latest version before use.