KBU8005 Datasheet, PDF (1/2 Pages) Fuji Electric – 8 AMP SILICON BRIDGE RECTIFIER

KBU8005 THRU KBU810
SILICON BRIDGE RECTIFIER
FEATURES
· Reliable low cost construction utilizing molded
plastic technique
· Ideal for printed circuit board
· Low forward voltage drop
· Low reverse leakage current
· High surge current capability
MECHANICAL DATA
Case: Molded plastic, KBU
Epoxy: UL 94V-O rate flame retardant
Terminals: Leads solderable per MIL-STD-202,
method 208 guaranteed
Mounting position: Any
Weight: 0.3ounce, 8.0gram
KBU
Dimensions in inches and (millimeters)
Maximum Ratings and Electrical Characteristics
Ratings at 25 ambient temperature unless otherwise specified.
Single phase, half wave, 60H_Z, resistive or inductive load.
For capacitive load, derate current by 20%.
Maximum Recurrent Peak Reverse Voltage
Maximum RMS Voltage
Maximum DC Blocking Voltage
Maximum Average Forward Rectified Current
.375"(9.5mm) Lead Length at T _A=55
Peak Forward Surge Current,
8.3ms single half-sine-wave
superimposed on rated load (JEDEC method)
Maximum Forward Voltage
at 8.0A DC and 25
Maximum Reverse Current
at T_A=25
at Rated DC Blocking Voltage
T_A=100
Typical Thermal Resistance (Note 2)
Typical Thermal Resistance (Note 3)
Operating and Storage Temperature Range
Symbols KBU8005 KBU801 KBU802 KBU804 KBU806 KBU808 KBU810 Units
V_RRM
50
100 200 400 600 800 1000 Volts
V_RMS
35
70
140 280 420 560 700 Volts
V_DC
50
100 200 400 600 800 1000 Volts
I_(AV)
8.0
Amp
I_FSM
125
Amp
V_F
I_R
R_θJA
R_θJC
T_J Tstg
1.1
10.0
500
18
3
-55 to +125
Volts
uAmp
/W
/W
NOTES:
1- Units mounted in free air, no heatsink, P.C.B. at 0.375" (9.5mm) lead length with 0.5 x 0.5” (12 x 12mm) copper pads
2- Units mounted on a 3.0 x 3.0” x 0.11" thick (7.5 x 7.5 x 0.3cm) Al. Plate heatsink
http://www.trr-jx.com