GBU6005 Datasheet, PDF (1/2 Pages) Diodes Incorporated – 6.0A GLASS PASSIVATED BRIDGE RECTIFIER

GBU6005 THRU GBU610
BRIDGE RECTIFIERS
FEATURES
· UL Recognized File # E469616
· Glass passivated chip junction
· Reliable low cost construction utilizing molded
plastic technique
· Ideal for printed circuit board
· Low forward voltage drop
· Low reverse leakage current
· High surge current capability
MECHANICAL DATA
Case: Molded plastic, GBU
Epoxy: UL 94V-O rate flame retardant
Terminals: Leads solderable per MIL-STD-202,
method 208 guaranteed
Mounting position: Any
Weight: 0.15ounce, 4.0gram
GBU
A
B
K
M
C
L
D
- ~~+
E
F
J
N
G
P
H
Dim Min Max
A
21.8 22.3
B
3.5
4.1
C
7.4
7.9
D
1.65 2.16
E
2.25 2.75
F
2.05 2.3
G
1.02 1.27
H
4.83 5.33
J
17.5 18.0
K
4.2 X 45°
L
18.3 18.8
M
3.30 3.56
N
0.46 0.56
P
0.76 1.0
Dimensions in millimeters
Maximum Ratings and Electrical Characteristics
Ratings at 25 ambient temperature unless otherwise specified.
Single phase, half wave, 60H_Z, resistive or inductive load.
For capacitive load, derate current by 20%.
Maximum Recurrent Peak Reverse Voltage
Maximum RMS Voltage
Maximum DC Blocking Voltage
Maximum Average Forward
Rectified Current at T_C=100 (Note 1 . Note 2)
Peak Forward Surge Current,
8.3ms single half-sine-wave
superimposed on rated load (JEDEC method)
Maximum Forward Voltage
at 3.0A DC and 25
Maximum Reverse Current
at T_A=25
at Rated DC Blocking Voltage
T_A=125
Typical Junction Capacitance (Note 3)
Typical Thermal Resistance (Note 2)
Typical Thermal Resistance (Note 1)
Operating and Storage Temperature Range
Symbols GBU6005 GBU601 GBU602 GBU604 GBU606 GBU608 GBU610
V_RRM
50
100 200 400 600 800 1000
V_RMS
35
70
140 280 420 560 700
V_DC
50
100 200 400 600 800 1000
Units
Volts
Volts
Volts
I_(AV)
6.0
Amp
I_FSM
125
Amp
V_F
I_R
C_J
R_θJA
R_θJC
T_J Tstg
1.0
5.0
500
100
45
22
4.2
-55 to +150
Volts
uAmp
pF
/W
/W
NOTES:
1- Unit case mounted on 2.0 x 2.0 x 0.06” thick (5.0 x5.0 x0.16cm) Al. Plate
2- Units mounted on P.C.B. with 0.5 x 0.5" (12 x 12mm) copper pads and 0.375" (9.5mm) lead length
3- Measured at 1 MH_Z and applied reverse voltage of 4.0 VDC.
4- Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw
http://www.trr-jx.com