HH-1355-6.3 Datasheet, PDF (1/1 Pages) JMK Inc. – The HH-1355-6.3C filter has been designed to operate with the VICOR Harmonic Attenuator Module (HAM)

JMK Inc
The HH-1355-6.3C filter has been designed to operate with the
VICOR Harmonic Attenuator Module (HAM). This filter was
specifically designed to allow the Vicor HAM and associated
power converters to meet Mil-Std-461C or Mil-Std-461D & E.
The enclosure mounting, and pin configuration are identical to
the enclosure for the standard HAM filter.
It will be necessary to add transient protection across the out-
put of the filter to protect the HAM module. It is recommended
that you use 5%, bipolar TVS diodes. 2 x 130V and 1 x 150V
diodes connected in series.
The HAM will meet Mil-Std-461C with the HH-1355-6.3 with
voltage inputs of 125 or 250 Vac.
It will also meet Mil-Std-461D,E, or F with a 125 volt input.
Additional circuitry is required on the input in order to meet
Mil-Std-461D, E, & F if 250 volts is the input voltage.
The additional circuitry is shown on the schematic.
HH-1355-6.3 Series
4-40 INSERT
.25 DP (4 PL)
4.60
0.25
2.50
0.30
2.40 2.00
1.80
0.20 _0.50
1.46
0.50
2.80
.080 DIA PIN (6 PL)
0.94
0.06
0.13 ±0.02
Operating voltage________________85 to 250 V~
Operating current ________________6.3 Amp
Operating frequency______________50/400 Hz
Operating temperature, High________See temp.curve
Operating temperature, Low ________-20º C, Std
________ -40º C, HT & BHT
________ _55º C, CHT
Diel. withstanding (line - case)_______1500 Vac
Diel. withstanding (line - line)________1500 Vdc
Leakage current__________________2.5 ma @ 220 V, 60 Hz
Max residual voltage after 1 sec__ 34 Volts
The filter is available in both the standard model and three
wider temperature range models.
The temperature ranges at full load are listed below:
HH-1355-6.3_______(-20—40º C)
HH-1355-6.3HT_____(-40—55º C)
HH-1355-6.3BHT___ (-40—70º C)
HH-1355-6.3CHT___ (-55—70º C)
USA JMK Inc 15 Caldwell Dr. Amherst, NH 03031 PH: 603 886-4100 FX: 603 886-4115
email: [e-mail]