JHG12864D Datasheet, PDF (6/25 Pages) Jewel Hill Electronic – SPECIFICATIONS FOR LCD MODULE

JEWEL HILL ELECTRONIC CO.,LTD.
4.2 BACKLIGHT DIMENSION AND SPECIFICATON.
1.ROHS must be complied.
2、结构尺寸 MECHANICAL OUTLINE
(未注尺寸公差Unspecified Tolerances is .X±0.3 .XX±0.2)
COLOR:WHITE
颜色：白色
遮光膜（黑白双面胶）
胶水固定
A
K
BLACK
RED
3、电路图CIRCUIT DIAGRAM (LED SMD 5 dies)
侧膜贴铝膜
BLACK
胶水固定
BLACK
RED
4.保存和焊接条件 STORAGE & SOLDERING CONDITIONS:
·Store with care. Storing the units
in bad condition will cause
the reflector sheet And decrease it's
adhesive power. Storage
·注意保存. 保存条件不好时.会降低反光膜
(扩散膜)与导光片(反射壳)的粘附力.
推荐保存条件为: 温度: 25℃±10℃
The products under the condition:
湿度: 65﹪RH±20﹪RH
temperature(25℃±10℃) and humidity
·焊接温度260℃±5℃,焊接时间小于3
(65﹪RH±20﹪RH) our recommendation.
·The Soldering Temperature is 260℃±5℃
and Soldering Time should be
秒,烙铁功率小于30W.
·焊接点应离产品实体大于1.6mm.
less than 3 sec, and soldering iron power
should be less than 30W.
·The soldering point should be farther than 1.6mm from body.
标识
ISSUE:
改正内容
AMENDMENT:
更改依据
RECTIFY BASIS：
日期
Date:
projection:
UNIT：mm
设计
DESIGH:
审核
Review:
会签
COUNTERSIGN:
批准
APPROVED:
日期
Date:
2010-03-22
日期
Date:
日期
Date:
日期
Date:
页码: 2 0f 1 版本:A1
JHG12864D
VER: 4.01
-5-
Issue date: 2013/08/01