JH43540960A Datasheet, PDF (13/23 Pages) Jewel Hill Electronic – SPECIFICATIONS FOR LCD MODULE

JEWEL HILL ELECTRONIC CO.,LTD.
9. 3 Reset Operation
(VCC=1.65~3.1 V)
10.Reliability and Inspection Standard
No.
Test Item
Test Conditions
Remark
Storage
1 High Temperature
Operation
80℃, 120Hr
70℃, 120Hr
Note
Note
Storage
2 Low Temperature
Operation
-30℃, 120Hr
-20℃, 120Hr
Note
High Temperature and High
3
Humidity
60℃, 90%RH, 120Hr
-10℃(1Hr)Æ25℃(5min)Æ60℃(1Hr)
Storage
32 Cycles
4 Temperature Cycle
-20℃(1Hr)Æ25℃(5min)Æ60℃(1Hr)
Operation
25 Cycles
5
Peeling Off (Storage)
≧500gf/cm
6
FPC Bending Test
≧6,000 times, 2/sec
Note
Note
Note
Note
50HZ, 30min,
7
Vibration Test(Storage)
Note
Amplitude: 2 cm, X/Y/Z directions
8
Drop Test
60cm/ 3Corner/ 8Face, 1Cycle
Note
Note:
1) The test samples should be applied to only one test item.
2) Sample size for each test item is 5~10pcs.
3) For Damp Proof Test, pure water(Resistance>1MΩ) should be used.
4) In case of malfunction defect caused by ESD damage, if it would be recovered to
normal state after resetting, it would be judged as a good part.
5) EL evaluation should be excepted from reliability test with humidity and temperature:
Some defects such as black spot/blemish can happen by natural chemical reaction
with humidity and fluorescence EL has.
6) After the reliability test, the test samples should be inspected after 2 hours at least.
7) Functional test is OK. Missing segment, shorts, unclear segment, non display,
JH43540960A VER: 1.0
- 12 -
Issue date: 2013/08/15