50S-1841 Datasheet, PDF (1/2 Pages) JFW Industries, Inc. – 1P2T SOLID STATE RF SWITCH

SPECIFICATION SHEET
JFW MODEL 50S-1841
1P2T SOLID STATE RF SWITCH
Frequency Range
Configuration
Impedance
VSWR
Insertion Loss
Isolation
Switching Speed
Switching Transients
RF Input Power
Spurious Noise
(Out-of-band)
Control (1 line)
DC Supply
RF Connector
JFW Industries, Inc.
Phone: [phone]
[e-mail]
www.jfwindustries.com
500-3000 MHz
1P2T
50 Ohms nominal
1.3:1 typical
1.5:1 maximum
0.50 dB typical 500-1000 MHz
0.75 dB maximum 500-1000 MHz
0.60 dB typical 1000-2000 MHz
0.90 dB maximum 1000-2000 MHz
0.90 dB typical 2000-3000 MHz
1.25 dB maximum 2000-3000 MHz
75 dB typical 500-2000 MHz
65 dB minimum 800-2000 MHz
65 dB typical 2000-3000 MHz
55 dB minimum 2000-3000 MHz
10 microseconds maximum
6 microseconds typical
(50% TTL to 10% or 90% RF)
< 1.0 Vpk-pk typical
< 2.0 Vpk-pk maximum (for any rep rate)
30 Watts average (Hot Switched)
This switch shall produce:
< -73dBm (100-500MHz)
< -50dBm (1-100MHz)
This is to be tested on the common port
with J1 and J2 terminated into 50 Ohms.
TTL "Low" Common to J1
TTL "High" Common to J2
+15 Vdc @ 80 mA nominal
and
+5 Vdc @ 40 mA nominal
BNC, SMA, TNC or N female
Page 1 of 2
--CONTINUED--
JFW FORM E-7-F REV F