50S-1821 Datasheet, PDF (1/2 Pages) JFW Industries, Inc. – 1P2T SOLID STATE RF SWITCH

SPECIFICATION SHEET
JFW MODEL 50S-1821
1P2T SOLID STATE RF SWITCH
Frequency Range
Configuration
Impedance
VSWR
Insertion Loss
Isolation
Switching Speed
Switching Transients
RF Input Power
(Cold Switched)
RF Input Power
(Hot Switched)
Spurious Noise
(Out-of-Band)
Control (1 line)
DC Supply
RF Connector
JFW Industries, Inc.
Phone: [phone]
[e-mail]
www.jfwindustries.com
800-3000 MHz
1P2T
50 Ohms nominal
1.4:1 maximum
0.60 dB typical 800-2000 MHz
1.00 dB maximum 800-2000 MHz
0.90 dB typical 2000-3000 MHz
1.30 dB maximum 2000-3000 MHz
75 dB typical 800-2000 MHz
65 dB minimum 800-2000 MHz
65 dB typical 2000-3000 MHz
55 dB minimum 2000-3000 MHz
10 microseconds maximum
6 microseconds typical
(50% TTL to 10% or 90% RF)
< 1.0 Vpk-pk typical
< 2.0 Vpk-pk maximum (for any rep rate)
75 Watts average (-20ºC to +50ºC)
50 Watts average (+50º to +70ºC)
30 Watts average (-20ºC to +70ºC)
This switch shall produce:
< -73dBm (100-800MHz)
< -50dBm (1-100MHz)
This is to be tested on the common port
with J1 and J2 terminated into 50 Ohms.
TTL "Low" Common to J1
TTL "High" Common to J2
+15 Vdc @ 80 mA nominal
and
+5 Vdc @ 40 mA nominal
BNC, SMA, TNC or N female
Page 1 of 2
--CONTINUED--
JFW FORM E-7-F REV F