30-7402-500 Datasheet, PDF (6/7 Pages) JDS Uniphase Corporation – Up to 660 mW Fiber Bragg Grating Stabilized 980 nm Pump Modules

6
Ordering Information
3000 SERIES PUMPS
For more information on this or other products and their availability, please contact your local JDSU account manager or
JDSU directly at 1-800-498-JDSU (5378) in North America and +800-5378-JDSU worldwide, or via e-mail at
[e-mail].
Sample: 30-7402-520
30-
-
Code
7402
7602
8000
Peak Wavelength
973.5 to 975.0 nm
975.0 to 977.0 nm
974.0 to 985.0 nm
Code
500
520
540
560
580
600
620
640
660
Minimum Kink-Free Power
500 mW
520 mW
540 mW
560 mW
580 mW
600 mW
620 mW
640 mW
660 mW
User Safety
Safety and Operating Considerations
The laser light emitted from this laser diode is invisible and may be harmful to the human eye. Avoid looking directly into the
fiber when the device is in operation.
CAUTION: THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT INCREASES EYE HAZARD.
Operating the laser diode outside of its maximum ratings may cause device failure or a safety hazard. Power supplies used with
this component cannot exceed maximum peak optical power.
CW laser diodes may be damaged by excessive drive current or switching transients. When using power supplies, the laser
diode should be connected with the main power on and the output voltage at zero. The current should be increased slowly
while monitoring the laser diode output power and the drive current. Careful attention to heatsinking and proper mounting
of this device is required to ensure specified performance over its operating life. To maximize thermal transfer to the heatsink,
the heatsink mounting surface must be flat to within .001” and the mounting screws must be torqued down to 1.5 in.-lb.
ESD PROTECTION — Electrostatic discharge (ESD) is the primary cause of unexpected laser diode failure. Take extreme
precaution to prevent ESD. Use wrist straps, grounded work surfaces, and rigorous antistatic techniques when handling laser diodes.