COM200ET003Y Datasheet, PDF (2/4 Pages) JDS Uniphase Corporation – WaveReadyTM Communication and Management Module

COMMUNICATIONS MODULE 200
2
Performance Specifications¹
Parameter
Electrical Characteristics
DC supply voltage²
Power dissipation
Physical Dimensions
Size (H x W x L)
Weight (approximate)
Mounting options
Environmental Characteristics
Operating ambient temperature
Storage temperature
Relative humidity (non-condensing)
Interface
DB-9/RS232
RJ45 or 10/100BaseT Ethernet
Front panel
Alarm relay signals
Backplane Connector
Electrical
Software and Management
TL1 command mode
WaveReady Node Manager
Minimum
Typical
Maximum
–48 V through WaveReady 3000-Series shelf
—
5W
8.5 W
17.27 x 2.54 x 21.84 cm (6.8 x 1.0 x 8.6 in)
0.54 kg (1.2 lb)
Mounts in a WaveReady 3000-Series shelf in a standard 19- or 23-inch telecommunications rack
–5°C
—
55°C
–40°C
—
85°C
5%
—
95%
Craft interface. 3-wire serial TTL, 9600 Baud, no parity, no flow control, 8 data bits, 1 stop bit craft interface.
Two auto-sense, auto-crossover Ethernet ports (ports A and B) for networking and daisy-chaining. One local craft access (LCA)
Ethernet port for local management and provisioning.
5 LEDs: CARD (power), CRIT (Critical Alarm), MAJ (Major Alarm), MIN (Minor Alarm), ACO (Alarm Cut-Off).
2 pushbuttons: ACO (Alarm Cut-Off)and INIT (Initialize)
4 ports:RS232 (DB-9/RS232),LCA (RJ45 Ethernet,local craft access) A and B (RJ45 Ethernet,network ports)
Dry contact, critical, major, and minor alarms. Relay is open under normal operation. Relay is closed when power is off or an alarm is
active.
A single 96-pin connector mounted on the backplane. Compatible with all WaveReady 3000-Series shelves.
Standard TL1 syntax,Telcordia® GR-811-CORE compliant. Supported through the RS232 craft interface or Ethernet on ports LCA or A.
Windows graphical user interface,TL1, and SNMPv3 supported through the RS232 craft interface or Ethernet on ports LCA or A.
Compatible with third-party management software, such as HP OpenView. Communication with remote modules through an
embedded supervisory channel is available for some modules.Requires JDSUWaveReady system software release 3.0 or above.
1_{Deploy product in accordance with each company's deployment directives.}
2_{The DC power supply must be –48 V SELV output and certified by a nationally recognized test laboratory (NRTL). UL tested at –48 V.}