DX4 Datasheet, PDF (1/10 Pages) Japan Aviation Electronics Industry, Ltd. – USB 2.0 Compatible Micro Connectors

COMPONENTS PRODUCT INFORMATION
NEW
USB 2.0 Compatible Micro Connectors ^CONNECTOR
DX4 Series
MB-0187-3
December 2014
RoHS Compliant
On-board Type
Mid-mount Type
The DX4 Series is a set of connectors compatible with the Micro-USB type USB 2.0 for
small devices standardized by the USB Implementers Forum, Inc.
Features
Compatible with Universal Serial Bus Micro-USB Cables and Connectors Specification,
Revision 1.01.
Connector type: USB 2.0 compatible, Micro types
Au plating over Pd-Ni alloy is used for mating cycle durability and long product life.
Superior rigidity with high-strength stainless steel shell.
Available in a variety of versions to suit diverse device configurations.
Two-piece shell structure for mid-mount type to prevent contact failure due to flux
scattering during reflow.
Available in reinforced type, with reinforcement plate set in mating area to prevent
damage from plug caused by misaligned mating. (Refer to drawing below)
Reinforcement plate
of mating area
Mating Area Reinforced Type
*In the above drawing the shell is transparent for illustration purposes to show the
reinforcement plate.
General Specifications
No. of Contacts: 5 positions
Contact Resistance:
30m ohm max. (initial)
Dielectric Withstanding Voltage:
AC500Vrms per minute
Insulation Resistance: 1000M ohm (initial)
Rated Current: DC1.8A (Vbus, GND)
Others DC0.5A
Rated Voltage: AC30Vrms
Durability: 10,000 mating cycles
Operating temperature:
-30 Deg. C to +80 Deg. C
JAE PMK Div. Proprietary. Copyright © 2014, Japan Aviation Electronics Industry, Ltd.
1/10