|
IXDD404 Datasheet, PDF (1/10 Pages) IXYS Corporation – 4 Amp Dual Low-Side Ultrafast MOSFET Driver | |||
|
PRELIMINARY DATA SHEET
IXDD404PI / 404SI / 404SIA / 404SI-16
4 Amp Dual Low-Side Ultrafast MOSFET Driver
Features
⢠Built using the advantages and compatibility
of CMOS and IXYS HDMOSTM processes
⢠Latch-Up Protected
⢠High Peak Output Current: 4A Peak
⢠Wide Operating Range: 4.5V to 25V
⢠Ability to Disable Output under Faults
⢠High Capacitive Load
Drive Capability: 1800pF in <15ns
⢠Matched Rise And Fall Times
⢠Low Propagation Delay Time
⢠Low Output Impedance
⢠Low Supply Current
⢠Two identical drivers in single chip
Applications
⢠Driving MOSFETs and IGBTs
⢠Limiting di/dt under Short Circuit
⢠Motor Controls
⢠Line Drivers
⢠Pulse Generators
⢠Local Power ON/OFF Switch
⢠Switch Mode Power Supplies (SMPS)
⢠DC to DC Converters
⢠Pulse Transformer Driver
⢠Class D Switching Amplifiers
General Description
The IXDD404 is comprised of two 4 Amp CMOS high speed
MOSFET drivers. Each output can source and sink 4 A of
peak current while producing voltage rise and fall times of less
than 15ns to drive the latest IXYS MOSFETS & IGBT's. The
input of the driver is compatible with TTL or CMOS and is fully
immune to latch up over the entire operating range. Designed
with small internal delays, cross conduction/current shoot-
through is virtually eliminated in the IXDD404. Improved speed
and drive capabilities are further enhanced by very low,
matched rise and fall times.
Additionally, each driver in the IXDD404 incorporates a unique
ability to disable the output under fault conditions. When a
logical low is forced into the Enable input of a driver, both of it's
final output stage MOSFETs (NMOS and PMOS) are turned
off. As a result, the respective output of the IXDD404 enters a
tristate mode and achieves a Soft Turn-Off of the MOSFET/
IGBT when a short circuit is detected. This helps prevent
damage that could occur to the MOSFET/IGBT if it were to be
switched off abruptly due to a dv/dt over-voltage transient.
The IXDD404 is available in the standard 8 pin P-DIP (PI),
SOP-8 (SI -with metal tab), SOP-8 (SIA -without metal tab) and
SOP-16 (SI-16) packages.
Figure 1 - Functional Diagram
ENA
200k
Vcc
OUTA
INB
ENB
GND
Copyright © IXYS CORPORATION 2001
200k
OUTB
First Release
|
▷ |