N155 Datasheet, PDF (2/4 Pages) Baumer IVO GmbH & Co. KG – Target Displays

Target Displays
Plug-on mount, enter key, manual format alignment
Display LCD two lines, interface RS485
Part number
N 155. 1
3 B X01
Display
B Horizontal at front
Voltage supply
3 24 VDC
E-connection
0 Connector output M8 with male and
female connector
1 Bottom cable output M8
2 Rear cable output M8
3 Bottom cable output M16
Interface
1 RS485
Accessories
Connectors and cables (page %S)
Z 178.A01 Adaptor cable between cable connector M8
and female M16, 1 m
Z 178.AW1 Cable connector M8, 4-pin, less cable with
integrated terminating resistor 120 Ω
Z 178.B01 Mating connector M8, 4-pin, less cable
Z 178.D05 Data and supply cable M8, Master to N 150
and N 155, 5 m
Z 178.S01 Cable connector M8, 4-pin, less cable
Z 178.V01 Coupling cable 1 m between M8 and M8
N 155
Description
The multicon spindle positioning system is completed by
a target display indicating also positions of hand wheels,
limits, linear units etc in close vicinity of the actuator. The
backlit LCD display provides the editing engineer with the
target parameters. The handshake key is saving the edited
parameters. Serial interface RS485 enables network of
maximum 32 target and spindle position displays with PC or
PLC.
For complete solutions also memory controllers as decen-
tralized operating and memory terminals are available.
2
www.baumerivo.com