N142 Datasheet, PDF (2/4 Pages) Baumer IVO GmbH & Co. KG – Spindle Position Displays

Spindle Position Displays
Hollow shaft max. ø25 mm, automatic format alignment
Display LCD two lines, interface RS485
N 142
Part number
N 142. 1
3A
01
Hollow shaft
A Hollow shaft ø25 mm
B Hollow shaft ø20 mm
Display
A Inclined
Voltage supply
3 24 VDC
E-connection
1 Cable output M16, motor cable 0.5 m
2 Cable output M16, motor cable 1.5 m
Interface
1 RS485
Accessories
Connectors and cables (page %S)
Z 165.A01 Adaptor cable between cable connector M16
and female M8, 1 m
Z 165.AW1 Cable connector M16, 5-pin, less cable with
integrated terminating resistor 120 Ω
Z 165.B01 Mating connector M16, 5-pin, less cable
Z 165.D05 Data and supply cable M16, Master to N 140,
N 141 and N 142, 5 m
Z 165.S01 Cable connector M16, 5-pin, less cable
Z 165.V01 Coupling cable between M16 and M16, 1 m
Description
multiconDrive represents a simplified and very efficient,
reasonably priced system for automatic format alignment.
With multiconDrive the spindle position displays communi-
cate directly with EC motors. Every spindle position display
is connected to the corresponding motor by a separate
cable output providing the motor without delay with the
signals “clockwise”, “counterclockwise”, “rotation speed” for
switchover to high/low speed.
The spindle position display provides two keys for clock-
wise and counterclockwise direction used during the first
editing operation. The key makes the motor moving into the
requested direction. A soft touch results in a defined STEP.
Thus, new spindle positions can be edited under direct
visual check of the operator with an accuracy of ±1/100 mm.
Shaft position parameters once set can be filed as profile in
the control. The serial interface enables network of maxi-
mum 32 spindle position displays with PC or PLC.
For complete solutions N 242 memory controller as operat-
ing and memory terminal is available. Up to 100 format
profiles can be stored by teach-in. The respective position
parameters can be retransmitted at any time as target to the
respecitve spindle position displays to release automatic
format alignment cycles.
2
www.baumerivo.com