GXP8W Datasheet, PDF (2/4 Pages) Baumer IVO GmbH & Co. KG – Absolute encoders - bus interfaces

Absolute encoders - bus interfaces
Shaft with clamping or synchro flange
Optical multiturn encoders 13 bit ST / 16 bit MT, DeviceNet
Part number
GXP8W.
20 M1 10
Interface
10 DeviceNet
E-connection
M1 Connector M12, 5-pin, radial
Voltage supply
20 10...30 VDC
Flange / Shaft
0 Clamping flange / ø10 mm IP 54
A Clamping flange / ø10 mm IP 65
1 Synchro flange / ø6 mm IP 54
B Synchro flange / ø6 mm IP 65
GXP8W - DeviceNet
Accessories
Connectors and cables (page %S)
Z 180.003 Female connector M12, 5-pin, 2 m cable
Z 180.005 Female connector M12, 5-pin, 5 m cable
Z 180.007 Female connector M12, 5-pin, 10 m cable
Mounting accessories (page %S)
Z 119.006 Eccentric fixing, single
Z 119.013 Adaptor plate for clamping flange for
modification into synchro flange
Z 119.015 Mounting adaptor for synchro flange
Z 119.017 Mounting angle for clamping flange
Z 119.035 Bearing flange for encoders with synchro
flange
DeviceNet features
Bus protocol
DeviceNet
Device profiles Device Profile for Encoders V 1.0
Operating mode
I/O-Polling
Cyclic
Change of State
Preset
This parameter is for setting the encoder
to a requested position value assigned
to a defined shaft position of the system.
The offset between the encoder zero
point and the mechanical zero point is
stored in the encoder.
Rotating direction
This parameter is for defining the
rotating direction in which there have to
be ascending or descending position
values.
Scaling
Parametering of steps per revolution
and of the total resolution.
Diagnosis
The encoder supports the following error
warnings:
- Position and parameter error
- Lithium battery voltage control
(Multiturn)
Default
125 kbit/s, Mac ID 63
2
www.baumerivo.com