GXN1H Datasheet, PDF (1/4 Pages) Baumer IVO GmbH & Co. KG – Absolute encoders - parallel

Absolute encoders - parallel
Hollow shaft ø14 mm
Multiturn encoder 12 bit ST / 12 bit MT / 250 cams
GXN1H
Features
–– Encoder multiturn / parallel
–– Optical sensing
–– Resolution: singleturn 12 bit, multiturn 12 bit
–– Hollow shaft ø14 mm
–– 250 cams freely programmable
–– 16 parallel outputs
–– Encoder programming by Windows software
–– RS232 encoder programming interface
–– Electronic setting to preset
GXN1H with hollow shaft
Technical data - electrical ratings
Voltage supply
10...30 VDC
Reverse polarity protection Yes
Consumption w/o load ≤50 mA (24 VDC)
Initializing time (typ.)
50 ms after power on
Interfaces
Parallel (cams), 5 special
outputs programmable
Number of cams
250
Steps per turn
4096 / 12 bit
Number of turns
4096 / 12 bit
Absolute accuracy
±0.03°
Sensing method
Optical
Code
Binary
Code sequence
CW/CCW coded by connection
Inputs
TxD, RxD (RS232)
Control signals UP/DOWN and
zero
ENABLE
Output circuit
PNP or NPN open collector
Interference immunity
DIN EN 61000-6-2
Emitted interference
DIN EN 61000-6-4
Programming interface RS232
Programmable
parameters
Steps per revolution
Number of revolutions
2 presets (limits)
Rotation speed monitoring
Diagnostic functions
Code continuity check
Signal frequency exceeded
Approval
UL approval / E63076
Technical data - mechanical design
Housing
Shaft
Protection DIN EN 60529
Operating speed
Rotor moment of inertia
Materials
Operating temperature
Relative humidity
Resistance
Weight approx.
E-connection
ø75 mm
ø14 mm hollow shaft
IP 54
≤6000 rpm (mechanical)
≤6000 rpm (electric)
20 gcm²
Housing: steel
Flange: aluminium
-25...+70 °C
95 % non-condensing
DIN EN 60068-2-6
Vibration 10 g, 16-2000 Hz
DIN EN 60068-2-27
Shock 200 g, 6 ms
700 g
Connector D-SUB, 37‑pin, 1 m
cable
1
www.baumerivo.com