DBMN-25S-N-A197 Datasheet, PDF (47/103 Pages) ITT Industries – A Historical Achievement of Technology Leadership

Cannon Combo D^®
Coaxial Assembly Instructions
Coaxial Assembly Instructions
Straight and 90° Coaxial Assembly
Step 1:
Slide the outer ring over the cable jacket.
Trim the cable as specified in the table of
Coaxial
Cable
Trim Dimensions (see this page). Insert
the cable dielectric and center conductor
into the inside diameter of the inner
sleeve. Then solder the center conductor
to the coaxial center contact.
Straight Coaxial
Outer Ring
Inner Sleeve
Soft Solder
90° Coaxial
Outer Ring
Inner Sleeve
Soft Solder
Straight and 90° Coaxial Assembly ^{Straight Coaxial}
Step 2:
Slide the outer ring forward until it is flush
with the coaxial shell containing the braid
between the outer ring and the inner
sleeve. For solder type coaxes, soft sol-
der the outer ring to the assembly through
the cross-drilled solder hold. For crimp
type coaxes, crimp with the appropriate
tool in the area defined.
Outer Ring
Solder
Coaxial Shell
Crimp
90° Coaxial
Solder ^{Outer Ring} _{Coaxial Shell}
Crimp
Soft Solder Cap into Shell
after Cable Assembly
on 90° Type Coaxes.
Coaxial Cable Trim Dimensions
Crimp Tooling
Straight Coaxial
RG Cable Number
196/U, 178B/U, 187/U, 188/U, 179B/U, 316B/U
58/U, 58B/U
90° Coaxial
RG Cable Number
196/U, 178B/U, 187/U, 188/U, 179B/U, 316B/U
58/U, 58B/U
RG Cable Number
Closure
196/U, 178B/U
187/U, 179B/U, 188/U, 316B/U
58/U, 58B/U
N
7,92 (.312)
9,52 (.375)
O
6,35 (.250)
7,92 (.312)
P
1,98 (.078)
1,98 (.078)
N
O
P
9,52
5,94
1,57
10,69
7,92
2,39
Tool Part Number
070051-0000
070051-0000
070051-0000
CCT-DM
CCT-DM
CCT-DM
Description
A
B
C
Hand Tool with integral die set for all coaxial
straight crimp braid.
Dimensions shown in mm
Specifications and dimensions subject to change
www.ittcannon.com
47