7101J1ZQE2 Datasheet, PDF (2/20 Pages) ITT Industries – Rocker and Lever Handle Switches

C&K 7000 Series
Rocker and Lever Handle Switches
Specifications
CONTACT RATING: B contact material: 0.4 VA max. @ 20 V AC or
DC max. Q contact material: 5 AMPS @ 120 V AC or 28 V DC;
2 AMPS @ 250 V AC. See page F-22 for additional ratings.
ELECTRICAL LIFE: 7X01 and UX1 models: 100,000 make-and-break
cycles at full load. All other models: 40,000 cycles.
CONTACT RESISTANCE: Below 10 milliohms typ. initial @ 2-4
V DC, 100 mA, for both silver and gold plated contacts.
INSULATION RESISTANCE: 10⁹ ohms min.
DIELECTRIC STRENGTH: 1000 V RMS min. @ sea level.
OPERATING TEMPERATURE: –30_C to 85_C.
SOLDERABILITY: Per MIL-STD-202F method 208D, or
EIA RS-186E method 9 (1 hour steam aging).
NOTE: Specifications and materials listed above are for switches with standard options.
For information on specific and custom switches, consult Customer Service Center.
Materials
CASE: Glass filled nylon 6/6, flame retardant, heat stabilized, or
diallyl phthalate (DAP) (UL 94V-0).
ACTUATOR: Nylon, black.
FRAME (FRONT MOUNT): Nylon, black.
FRAME (REAR MOUNT): Spring steel, black.
BUSHING: Brass or zinc, nickel plated.
HOUSING: Stainless steel.
SWITCH SUPPORT: Brass or steel, tin plated.
END CONTACTS: B contact material: Copper alloy, with gold plate over
nickel plate. Q contact material: Coin silver, silver plated. See page
F-22 for additional contact materials.
CENTER CONTACTS & ALL TERMINALS: B contact material: Copper
alloy, with gold plate over nickel plate. Q contact material: Copper
alloy, silver plated. See page F-22 for additional contact materials.
TERMINAL SEAL: Epoxy.
HARDWARE: Mounting nuts & screws: Brass. Lockwasher: Stainless
steel. Standoff: Nylon standard, aluminum available, consult
Customer Service Center.
SWITCHES WITH STANDARD OPTIONS
7101J1ZQE2
SPDT
PART NUMBER
7101J1ZQE2
ÑÑÑÑÑÑ ^{POS. 1 POS. 2 POS. 3}
ON
NONE
ON
NOTE: For PC termination, replace ‘Z’ with ‘C’.
For panel mounting information, see page F-7.
F
7201J1ZQE2
DPDT
ITT Industries
Cannon
F-4
PART NUMBER
7201J1ZQE2
ÑÑÑÑÑÑ ^{POS. 1 POS. 2 POS. 3}
ON
NONE
ON
NOTE: For PC termination, replace ‘Z’ with ‘C’.
For panel mounting information, see page F-7.
www.ittcannon.com