English
Language : 

SLC Datasheet, PDF (13/16 Pages) ITT Industries – Snap/Clip-Lock Environmentally Sealed - Circular
Snap/Clip-Lock Environmentally Sealed - Circular
Cannon SLC/SLC-T/CLC
Hand Crimp Tool Operation
Hand Crimp Tool - CCT - SLC / SLE
Part Number: 995-0002-232
The CCT-SLC/SLE hand crimp tool is designed to crimp individual SLC/SLE contacts on wire sizes 16, 18, and 20 AWG.
Each cycle is ratchet-controlled (The tool must be completely closed before it can be reopened) to assure a satisfactory
crimp each time. Over and under crimps are eliminated.
This tool is for use when the requirement is for low to moderate volume quantities, and for on-site applications where semi-
automatic tools cannot be practically used.
1. Cycle the CCT - SLE / SLC hand tool to the open
position.
2. While pressing upward on the locator spring, insert
the contact with tails upward completely into the
locator.
3. When correctly positioned the contact should be
located beyond flush with the edge of the CCT - SLE
/ SLC and positioned in the concave polished split
level crimp.
4. Partially (usually the first click) Cycle the hand tool
assuring that the upward thrusting tails of the contact
has started engaging with the top jaw of the tool.
(There is a slight tendency for the contact to roll out
of vertical alignment.)
5. Insert the pre-stripped wire into the crimp area of
the contact and completely cycle the tool.
6. While pressing upward on the locator spring
withdraw the crimp termination.
Wire Stripping
7. The result will be a perfect termination.
8. Note that there are no unterminated wire strands,
and that some strand ends can be seen at the
forward edge of the crimp. Also note the insulation is
gripped by the smaller secondary crimp. Distortion is
at a minimum, both axially and laterally - no sharp
edges.
Tolerance
Low
High
5 and 13 A Contact
A
B
2,41 (.095)
5,33 (.210)
3,30 (.130)
5,59 (.220)
Dimensions shown in mm
Specifications and dimensions subject to change
www.ittcannon.com
16