050-000-0030070 Datasheet, PDF (1/2 Pages) ITT Industries – 12-POINT CENTER PIN CRIMP TOOL

12-POINT CENTER PIN
CRIMP TOOL
ITT Industries
DATASHEET
THIS HAND TOOL MUST NOT BE USED IN ANY POWERED
SEE REVERSE SIDE FOR IMPORTANT INFORMATION
"PRESS AS DEFINED BY OSHA CFR 1910.211 (46).
CONCERNING REPAIR AND CALIBRATION INFORMATION.
GENERAL INFORMATION
• Part number of the tool refers to both the positioner
and the tool frame as a combined unit.
• The tool has a double action ratchet. Note that the
tool cannot be opened without completing the
crimp cycle.
SPECIFICATIONS
TOOL NO. 050-000-0030070
CONTACT AND WIRE ENTER HERE
DATAPLATE
CRIMPING INSTRUCTIONS
1. With the tool in the open position, insert the contact
and the prepared wire through the indenter opening
and into the positioner.
2. Squeeze the handles together until the ratchet
releases. The handles will return to the open position.
Remove the crimped contact and wire.
FIXED
POSITIONER
TOOL IN OPEN
POSTION
TOOL IN CLOSED
POSTION
GAGING INSTRUCTIONS
"GO GAGING"
Operate the tool to the fully closed position. Maintain firm hand
pressure on the tool handles. Insert the "GO" gage end as shown.
The gage must pass freely between the indenter tips.
"NO-GO GAGING"
Operate the tool to the fully closed position. Maintain firm hand
pressure on the tool handles. Try to insert the "NO-GO" gage end as
shown. The "NO-GO" gage may partially enter the indenter opening,
but must not pass completely through the opening.
GREEN
CAUTION!
DO NOT CRIMP GAGE!
RED
GREEN "GO"
RED "NO-GO"
INDENTER
INDENTER
050-000-0030073
ITT INDUSTRIES, 100 SEBETHE DRIVE, CROMWELL, CT 06416
COPYRIGHT© 2000 ITT INDUSTRIES, USA
PHONE [phone] FAX [phone]
ALL RIGHTS RESERVED
12/00
REV. A
FILE # DS0148
DOC # AFMSP-76-DS