IS31BL3230-QFLS2-TR Datasheet, PDF (1/12 Pages) Integrated Silicon Solution, Inc – 8 CHANNELS CONSTANT CURRENT LED DRIVER WITH PWM BRIGHTNESS CONTROL

IS31BL3230
8 CHANNELS CONSTANT CURRENT LED DRIVER
WITH PWM BRIGHTNESS CONTROL
March 2015
GENERAL DESCRIPTION
The IS31BL3230 provides eight regulated current
sources, each delivers up to 90mA of load current with
careful selection of external sense resistors, all outputs
at the IS31BL3230 may be connected in parallel to
enable the current through the LED to be as high as
720mA.
The IS31BL3230 does not include a charge pump and
therefore has no noise and significantly improved the
efficiency. The external resistor, R_SET1, determines the
constant current output of ports LED1 thru LED4, while
resistor R_SET2 determines the constant current output of
ports LED5 thru LED8.
Brightness can be controlled with PWM techniques. The
constant current source is set with two external sense
resistors.
Alternatively, a PWM signal applied to the PWM pin can
vary the perceived brightness of the LED. The device is
in shut down mode when the PWM Input is logic low.
FEATURES
 Ultra low headroom voltage
 Total output current can be 720mA
 Cost effective LED driver
 Current adjustable via external resistors
 Best noise and efficiency performance
 Highly integrated design, minimal component
 1.6μA (Typ.) shutdown current
 Small package QFN-16 (3mm×3mm)
APPLICATIONS
 Flash LED driver
 Backlight LED driver
TYPICAL APPLICATION CIRCUIT
Figure 1 Typical Application Circuit for Flash LED Driving
Integrated Silicon Solution, Inc. – www.issi.com
1
Rev. B, 02/09/2015