GAU205P-15402 Datasheet, PDF (7/8 Pages) Isahaya Electronics Corporation – Universal Gate Drive Prototype Board

FOR SAFETY USING
Great detail and careful attention are given to the production activity of Hics, such as the development, the quality of production, and in
it’s reliability. However the reliability of Hics depends not only on their own factors but also in their condition of usage. When handling
Hics, please note the following cautions.
CAUTIONS
Packing
The materials used in packing Hics can only withstand normal external conditions.
When exposed to outside shocks, rain and certain environmental contaminators, the packing materials will deteriorates. Please
take care in handling.
Carrying
1)Don’t stack boxes too high. Avoid placing heavy materials on boxes.
2)Boxes must be positioned correctly during transportation to avoid breakage.
3)Don't throw or drop boxes.
4)Keep boxes dry. Avoid rain or snow.
5)Minimal vibration and shock during transportation is desirable.
Storage
When storing Hics, please observe the following notices or possible deterioration of their electrical characteristics, risk of solder
ability, and external damage may occur.
1)Devices must be stored where fluctuation of temperature and humidity is minimal, and must not be exposed to direct sunlight.
Store at the normal temperature of 5 to 30 degrees Celsius with humidity at 40 to 60%.
2)Avoid locations where corrosive gasses are generated or where much dust accumulates.
3)Storage cases must be static proof.
4)Avoid putting weight on boxes.
Extended storage
When extended storage is necessary, Hics must be kept non‐processed. When using Hics which have been stored for more than
one year or under severe conditions, be sure to check that the exterior is free from flaw and other damages.
Maximum ratings
To prevent any electrical damages, use Hics within the maximum ratings. The temperature, current, voltage, etc. must not
exceed these conditions.
Polarity
To protect Hics from destruction and deterioration due to wrong insertion, make sure of polarity in inserting leads into the
board holes, conforming to the external view for the terminal arrangement.
http://www.idc-com.co.jp