SM-BGA-9053 Datasheet, PDF (2/4 Pages) Ironwood Electronics. – Ball guide prevents over compression of elastomer

A1 mark on Socket Base
30.48±0.05
Mounting Hole Location
26.87±0.05
Alignment Hole Location
4X 2.35±0.10 THRU ALL
NON-PLATED
MOUNTING HOLES
38.10
Socket Base Outline
484X 0.50 MIN PADS
Dashed line shows insulation plate
(details on page 4)
1.00 typ
21.00±0.05
4X 0.66±0.025 THRU ALL
NON-PLATED
ALIGNMENT HOLES
Description: Recommended PCB Layout
Primary dimension units are millimeters, Secondary dimension units are [inches], Weight is in grams.
Tolerances: Hole diameters ±0.03mm [±0.001"], Pitches (from true position) ±0.025mm [±0.001"], substrate thickness tolerance ±10%, all
other tolerances ±0.13mm [±0.005"] unless stated otherwise. Materials and specifications are subject to change without notice.
SM-BGA-9053 Drawing
Ironwood Electronics, Inc.
Tele: [phone]
www.ironwoodelectronics.com
Material: N/A
Finish: N/A
Weight: 57.02
Target PCB Recommendations
Total thickness: 1.6mm min.
Plating: Gold or Solder finish
PCB Pad height: same or higher than solder mask
STATUS: Released
ENG: B. Schatz
FILE: SM-BGA-9053 Dwg
SHEET: 2 OF 4
DRAWN BY: M. Raske
DATE: 10/21/2014
REV. A
SCALE: 5:2