IRF1607PBF_15 Datasheet, PDF (7/9 Pages) International Rectifier – Ultra Low On-Resistance

1000
Duty Cycle = Single Pulse
100
0.01
0.05
10
0.10
IRF1607PbF
Allowed avalanche Current vs
avalanche pulsewidth, tav
assuming ∆ Tj = 25°C due to
avalanche losses
1
1.0E-07
1.0E-06
1.0E-05
1.0E-04
tav (sec)
1.0E-03
Fig 15. Typical Avalanche Current Vs.Pulsewidth
1.0E-02
1.0E-01
1400
1200
1000
TOP
Single Pulse
BOTTOM 10% Duty Cycle
ID = 85A
800
600
400
200
0
25
50
75
100 125 150
Starting TJ , Junction Temperature (°C)
Fig 16. Maximum Avalanche Energy
Vs. Temperature
www.irf.com
Notes on Repetitive Avalanche Curves , Figures 15, 16:
(For further info, see AN-1005 at www.irf.com)
1. Avalanche failures assumption:
Purely a thermal phenomenon and failure occurs at a
temperature far in excess of T_jmax. This is validated for
every part type.
2. Safe operation in Avalanche is allowed as long asT_jmax is
not exceeded.
3. Equation below based on circuit and waveforms shown in
Figures 12a, 12b.
4. P_{D (ave)} = Average power dissipation per single
avalanche pulse.
5. BV = Rated breakdown voltage (1.3 factor accounts for
voltage increase during avalanche).
6. I_av = Allowable avalanche current.
7. ∆T = Allowable rise in junction temperature, not to exceed
T_jmax (assumed as 25°C in Figure 15, 16).
t_{av =} Average time in avalanche.
175 D = Duty cycle in avalanche = tav ·f
Z_thJC(D, t_av) = Transient thermal resistance, see figure 11)
P_{D (ave)} = 1/2 ( 1.3·BV·I_av) = DT/ Z_thJC
I_av = 2DT/ [1.3·BV·Z_th]
E_{AS (AR)} = P_{D (ave)}·t_av
7