AUIPS6021_15 Datasheet, PDF (3/17 Pages) International Rectifier – INTELLIGENT POWER HIGH SIDE SWITCH

AUIPS6021(S)(R)
Absolute Maximum Ratings
Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. All voltage parameters
are referenced to Ground lead. Tj= -40°C..150°C, Vcc=6..35V (unless otherwise specified).
Symbol Parameter
Min. Max. Units
Vout
Maximum output voltage
Vcc-35 Vcc+0.3
Voffset
Maximum logic ground to load ground offset
Vcc-35 Vcc+0.3
Vin
Vcc max.
Maximum input voltage
Maximum Vcc voltage
-0.3 5.5

36
V
Vcc cont. Maximum continuous Vcc voltage

28
Vcc sc.
Maximum Vcc voltage with short circuit protection

28
Iin max.
Idg max.
Maximum IN current
Maximum diagnostic output current
-3
-3
10
10
mA
Vdg
Maximum diagnostic output voltage
-0.3 5.5
V
Maximum power dissipation (internally limited by thermal protection)
Pd
Rth=5°C/W AUIPS6021
Rth=40°C/W AUIPS6021S 1”sqrt. footprint


25
3.1
W
Rth=50°C/W AUIPS6021R 1”sqrt. footprint

2.5
Tj max.
Max. storage & operating temperature junction temperature
-40 150
°C
Tsoldering Soldering temperature (10 seconds)

300
°C
Thermal Characteristics
Symbol
Parameter
Rth1
Thermal resistance junction to ambient AUIPS6021 TO220 free air
Rth2
Thermal resistance junction to case AUIPS6021 TO220
Rth1
Thermal resistance junction to ambient AUIPS6021S D²Pak std. footprint
Rth2
Rth3
Thermal resistance junction to ambient AUIPS6021S D²Pak 1” sqrt.
Footprint
Thermal resistance junction to case AUIPS6021S D²Pak
Rth1
Thermal resistance junction to ambient AUIPS6021R D-Pak std. footprint
Rth2
Thermal resistance junction to ambient AUIPS6021R D-Pak 1” sqrt.
Footprint
Rth3
Thermal resistance junction to case AUIPS6021R D-Pak
Typ.
50
2.6
60
40
2.6
70
50
2.6
Max.








Units
°C/W
Recommended Operating Conditions
These values are given for a quick design. For operation outside these conditions, please consult the application notes.
Symbol
Parameter
Min. Max. Units
VIH
High level input voltage
4
5.5
VIL
Low level input voltage
0
0.9
Iout
Continuous drain current, Tambient=85°C, Tj=125°C, Vin=5V
Rth=5°C/W AUIPS6021

12
A
Rth=40°C/W AUIPS6021S 1” sqrt. footprint

4.3
Rth=50°C/W AUIPS6021R 1” sqrt. footprint

3.9
Rin
Recommended resistor in series with IN pin
4
10
Rdgs
Rdgp
Recommended resistor in series with DG pin for reverse battery protection 4
Recommended pull-up resistor for DG
4
20
20
kΩ
Rol
Recommended pull-up resistor for open load detection
5
100
F max.
Max. switching frequency

1.5 kHz
3 www.irf.com
© 2012 International Rectifier
February 3, 2013