IR3590_15 Datasheet, PDF (1/1 Pages) International Rectifier – Digital Multi-Phase Redundant Controller

Digital Multi-Phase Redundant Controller
IR3590
FEATURES
 6-phase single loop configurable PWM Controller
 Serial I2C control for Vout changes
 Programmable Constant Current Protection
 Dead-phase Protection and Flag
 Min/Max Telemetry registers and real-time
monitoring via I2C (IIN, VIN, IOUT, VOUT, Temp)
 Programmable 1-phase or 2-phase for Light Loads
and Active Diode Emulation for Very Light Loads
 IR Adaptive Transient Algorithm (ATA) minimizes
output bulk capacitors and system cost
 IR Efficiency Shaping Features including Variable
Gate Drive and Dynamic Phase Control
 Auto-Phase Detection with auto-compensation
 Fault Protection: Output OVP, UVP, OC Warn,
OCP, OT Warn, OTP
 Multiple Time Programming (MTP) with integrated
charge pump for easy custom configuration
 Compatible with IR ATL and 3.3V tri-state Drivers
 200kHz to 2MHz switching frequency per phase
 +3.3V supply voltage; -40°C to 85°C Ambient
 Pb-Free, Halogen Free, RoHS, 5x5mm, 40-pin,
0.4mm pitch QFN
APPLICATIONS
 Supports Phase Redundant based Server
systems
 Server CPU
 Server Memory
DESCRIPTION
The IR3590 is a 6-phase digital, single loop, multi-
phase buck controller with a feature set optimized to
support redundant power supply systems. The
IR3590 includes IR’s Efficiency Shaping Technology
to deliver exceptional efficiency at minimum cost
across the entire load range. IR Variable Gate Drive
optimizes the MOSFET gate drive voltage based on
real-time load current. IR’s Dynamic Phase Control
adds/drops phases based upon load current. The
IR3590 can be configured to enter 1-phase
operation and active diode emulation mode
automatically or by command.
IR’s unique Adaptive Transient Algorithm (ATA),
based on proprietary non-linear digital PWM
algorithms, minimizes output bulk capacitors, and
improves transient response and form factor.
The I2C interface can communicate with up to 127
IR3590-based VR loops. Device configuration and
fault parameters are easily defined using the IR
Digital Power Design Center (DPDC) GUI and stored
in on-chip MTP. MTP storage saves pins and
enables a small package size.
The IR3590 extensive fault protection includes
output OV, UV and OC protection, a thermistor
based OT protection input with a VRHOT signal
output, and a selectable and separate Over Current
warning flag through the ALERT#
ORDERING INFORMATION
Base Part
Number
IR3590
Package Type
QFN 5 mm x 5 mm
Standard Pack
Form
Quantity
Tape and Reel
3000
Orderable
Part Number
IR3590MxxyyTRP²
IR3590
QFN 5 mm x 5 mm
Tape and Reel
3000
IR3590MTRPBF¹
IR3590
QFN 5 mm x 5 mm
Tray
4900
IR3590MTYPBF¹
Notes:
1. Unprogrammed/blank parts will not start up until programmed in order to ensure a safe power up.
2. Customer Specific Configuration File, where xx = Customer ID and yy = Configuration File (Codes assigned by IR Marketing).
1 www.irf.com | © 2014 International Rectifier
February 4, 2014 | V2.05