IR2133 Datasheet, PDF (1/12 Pages) International Rectifier – 3-PHASE BRIDGE DRIVER

Data Sheet No. PD60107 revU
IR2133/IR2135(J&S^{) & (PbF)}
IR2233^/IR2235⁽J&S⁾
3-PHASE BRIDGE DRIVER
Features
• Floating channel designed for bootstrap operation
Fully operational to +600V or+1200V
Tolerant to negative transient voltage
dV/dt immune
• Gate drive supply range from 10V/12V to 20V DC and
up to 25V for transient
• Undervoltage lockout for all channels
• Over-current shut down turns off all six drivers
• Independent 3 half-bridge drivers
• Matched propagation delay for all channels
• 2.5V logic compatible
• Outputs out of phase with inputs
• Also available LEAD-FREE
Product Summary
V_OFFSET
I_O+/-
V_OUT
t_on/off (typ.)
Deadtime (typ.)
600V or 1200V max.
200 mA / 420 mA
10 - 20V or 12 - 20V
750/700 ns
250 ns
Packages
Description
The IR2133IR2135/IR2233IR2355 (J&S) are high voltage, high
speed power MOSFET and IGBT driver with three independent 28-Lead SOIC
high side and low side referenced output channels for 3-phase
applications. Proprietary HVIC technology enables ruggedized
28-Lead PDIP
monolithic construction. Logic inputs are compatible with CMOS
or LSTTL outputs, down to 2.5V logic. An independent opera-
44-Lead PLCC w/o 12 leads
tional amplifier provides an analog feedback of bridge current via an external current sense resistor. A current trip
function which terminates all six outputs can also be derived from this resistor. A shutdown function is available to
terminate all six outputs. An open drain FAULT signal is provided to indicate that an over-current or undervoltage
shutdown has occurred. Fault conditions are cleared with the FLT-CLR lead. The output drivers feature a high pulse
current buffer stage designed for minimum driver cross-conduction. Propagation delays are matched to simplify use in
high frequency applications. The floating channels can be used to drive N-channel power MOSFETs or IGBTs in the
high side configuration which operates up to 600 volts or 1200 volts.
Typical Connection
up to 600V or 1200V
(Refer to Lead Assignments for correct pin configuration). This/These diagram(s) show electrical connections only.
Please refer to our Application Notes and DesignTips for proper circuit board layout.
www.irf.com
1