|
HFA200MD40C Datasheet, PDF (1/5 Pages) International Rectifier – Ultrafast, Soft Recovery Diode | |||
|
PD-2.450 rev. B 01/99
HEXFREDTM
Features
 Reduced RFI and EMI
 Reduced Snubbing
 Extensive Characterization of
Recovery Parameters
HFA200MD40C
Ultrafast, Soft Recovery Diode
LUG
LUG
LUG
TERMINAL TERMINAL TERMINAL
ANODE 1 CATHODE ANODE 2
Isolated Base
VR = 400V
VF(typ.)Â = 0.9V
IF(AV) = 200A
Qrr (typ.) = 330nC
IRRM(typ.) = 8.1A
trr(typ.) = 45ns
di(rec)M/dt (typ.) = 270A/µs
Description
HEXFREDTMdiodes are optimized to reduce losses and EMI/RFI in high frequency
power conditioning systems. An extensive characterization of the recovery
behavior for different values of current, temperature and di/dt simplifies the
calculations of losses in the operating conditions. The softness of the recovery
eliminates the need for a snubber in most applications. These devices are
ideally suited for power converters, motors drives and other applications where
switching losses are significant portion of the total losses.
Absolute Maximum Ratings (per Leg)
TO-244AB
(ISOLATED)
VR
IF @ TC = 25°C
IF @ TC = 100°C
IFSM
EAS
PD @ TC = 25°C
PD @ TC = 100°C
TJ
TSTG
Parameter
Cathode-to-Anode Voltage
Continuous Forward Current
Continuous Forward Current
Single Pulse Forward Current Â
Non-Repetitive Avalanche Energy Â
Maximum Power Dissipation
Maximum Power Dissipation
Operating Junction and
Storage Temperature Range
Max.
400
172
83
1200
1.4
278
111
-55 to +150
Units
V
A
mJ
W
C
Thermal - Mechanical Characteristics
Parameter
Min.
Typ.
Max. Units
RthJC
RthCS
Junction-to-Case, Single Leg Conducting
Junction-to-Case, Both Legs Conducting
Case-to-Sink, Flat , Greased Surface
ÂÂÂÂ
ÂÂÂÂ
ÂÂÂÂ
ÂÂÂÂ
ÂÂÂÂ
0.10
0.45
0.23
ÂÂÂÂ
°C/W
K/W
Wt
Weight
ÂÂÂÂ
79 (2.8)
ÂÂÂÂ g (oz)
Mounting Torque Â
Terminal Torque
30 (3.4)
30 (3.4)
ÂÂÂÂ
ÂÂÂÂ
40 (4.6) lbfÂin
40 (4.6) (NÂm)
Vertical Pull
2 inch Lever Pull
ÂÂÂÂ
ÂÂÂÂ
ÂÂÂÂ
ÂÂÂÂ
80
lbfÂin
35
Note: Â Limited by junction temperature
 L = 100µH, duty cycle limited by max TJ
 125°C
 Mounting surface must be smooth, flat, free or burrs or other
protrusions. Apply a thin even film or thermal grease to mounting
surface. Gradually tighten each mounting bolt in 5-10 lbfÂin steps
until desired or maximum torque limits are reached. Module
1
|
▷ |