HFA100MD60D Datasheet, PDF (1/5 Pages) International Rectifier – Ultrafast, Soft Recovery Diode

HEXFRED^TM
Features
• Reduced RFI and EMI
• Reduced Snubbing
• Extensive Characterization of
Recovery Parameters
PD-2.507 rev. A 12/98
HFA100MD60D
Ultrafast, Soft Recovery Diode
Anode AC Cathode
1
2
Isolated Base
V_R = 600V
V_F(typ.)ƒ = 1.1V
I_F(AV) = 100A
Q_rr (typ.) = 300nC
I_RRM(typ.) = 8A
t_rr(typ.) = 33ns
di_(rec)M/dt (typ.)ƒ = 240A/µs
Description
HEXFRED^TM diodes are optimized to reduce losses and EMI/RFI in high frequency
power conditioning systems. An extensive characterization of the recovery
behavior for different values of current, temperature and di/dt simplifies the
calculations of losses in the operating conditions. The softness of the recovery
eliminates the need for a snubber in most applications. These devices are ideally
suited for power converters, motors drives and other applications where
switching losses are significant portion of the total losses.
Absolute Maximum Ratings (per Leg)
Parameter
Max.
TO-244AB
(ISOLATED)
Units
VR
IF @ TC = 25°C
IF @ TC = 100°C
IFSM
EAS
PD @ TC = 25°C
PD @ TC = 100°C
TJ
TSTG
Cathode-to-Anode Voltage
Continuous Forward Current
Continuous Forward Current
Single Pulse Forward Current 
Non-Repetitive Avalanche Energy ‚
Maximum Power Dissipation
Maximum Power Dissipation
Operating Junction and
Storage Temperature Range
600
V
83
40
A
400
220
µJ
180
W
71
-55 to +150
C
Thermal - Mechanical Characteristics
Parameter
Min.
Typ.
Max. Units
R_thJC
R_thCS
Wt
Junction-to-Case, Single Leg Conducting
Junction-to-Case, Both Legs Conducting
Case-to-Sink, Flat , Greased Surface
Weight
––––
––––
––––
––––
––––
––––
0.10
79 (2.8)
0.70
0.35
––––
––––
°C/W
K/W
g (oz)
Mounting Torque „
Terminal Torque
30 (3.4)
30 (3.4)
––––
––––
40 (4.6) lbf•in
40 (4.6) ^(N•m)
Vertical Pull
2 inch Lever Pull
––––
––––
––––
––––
80
lbf•in
35
Note:  Limited by junction temperature
‚ L = 100µH, duty cycle limited by max T_J
ƒ 125°C
„ Mounting surface must be smooth, flat, free or burrs or other
protrusions. Apply a thin even film or thermal grease to mounting
surface. Gradually tighten each mounting bolt in 5-10 lbf•in steps
until desired or maximum torque limits are reached. Module
1