ARM2815T Datasheet, PDF (1/14 Pages) International Rectifier – HYBRID-HIGH RELIABILITY 1MEGA-RAD HARDENED DC-DC CONVERTER

HYBRID-HIGH RELIABILITY
1MEGA-RAD HARDENED
DC-DC CONVERTER
PD-94530C
ARM28XXT SERIES
28V Input, Triple Output
Description
The ARM Series of three output DC-DC converters are
designed specifically for use in the high-dose radiation
environments encountered during deep space planetary
missions. The extremely high level of radiation tolerance
inherent in the ARM design is assured as a result of extensive
research, thorough analysis and testing, careful selection
of components and lot verification testing of finished hybrids.
Many of the best circuit design features characterizing
earlier IR HiRel products have been incorporated into the ARM
topology. Capable of uniformly high performance through
long term exposures in radiation intense environments,
this series sets the standard for distributed power systems
demanding high performance and reliability.
The ARM converters are hermetically sealed in a rugged,
low profile package utilizing copper core pins to minimize
resistive DC losses. Long-term hermetically is assured
through use of parallel seam welded lid attachment along
with IR HiRel rugged ceramic pin-to-package seal. Axial lead
orientation facilitates preferred bulkhead mounting to the
principal heat-dissipating surface.
Manufactured in a facility fully qualified to MIL-PRF-
38534, these converters are fabricated utilizing DLA Land
and Maritime qualified processes. For available screening
options, refer to device screening table in the data sheet.
Variations in electrical, mechanical and screening specifications
can be accommodated. Contact IR HiRel San Jose for special
requirements.
ARM
Features
 Total Dose > 1 MRads(Si)
 SEE Hardened to LET up to 83 MeV.cm²/mg
 De-rated per MIL-STD-975 & MIL-STD-1547
 Output Power Range 3 to 30 Watts
 19 to 50 Volt Input Range
 Input Under voltage Lockout
 High Electrical Efficiency > 80%
 Full Performance from -55°C to +125°C
 Continuous Short Circuit Protection
 12.8 W/in³ Output Power Density
 True Hermetic Package
 External Inhibit Port
 Externally Synchronization
 Fault Tolerant Design
 5V, ±12V or 5V, ±15V Outputs Available
1
2016-07-01