F44KU6806G50BLK Datasheet, PDF (1/3 Pages) IRC - a TT electronics Company. – High Voltage Thick Film Resistor

High Voltage Thick Film
Resistor
F Series
• Termination variants
• Wide resistance range
• Good resistance stability
• Working voltage up to 28KV
• Sets available with matched characteristics
• Good ratio matching over wide voltage range
• Series connection of resistors by screw terminals
������������������
���������������������
����������
����������
��������������������
Electrical Data
IRC
Type
Power
Rating @
20°C
(watts)
Resistance
Range
(ohms)
Limiting
Element
Voltage
(volts)
In Air In Oil
TCR
Resistance
(±ppm/°C) Tolerance (%)
(values>1G:
TCR is 250ppm/°C)
(measured at 100
volts dc)
Values
(any value to
special order)
Thermal
Impedance
(°C/watt)
Operating
Temperature
Range (°C)
F43
0.7
2M to 100G 4K 8K
-2000
F44
1.3
2M to 150G 14K 28K
-2000
2, 5, 10
EIA 2%
44
values
2, 5, 10
preferred
33
-55 to 100
-55 to 100
CONSTRUCTION:
The Cermatox^® sintered oxide based resistive thick film is fired
onto the surface of a high quality ceramic onto which turned
brass end caps are pressed. A helical cut is made into the film
to adjust its ohmic value and finally a sleeve is fitted to provide
mechanical protection and electrical insulation. Resistors for use
in oil or SF₆ can be supplied with a lacquer protection instead
of the sleeve.
TERMINATIONS:
Three styles of termination are available to permit resistors to
be screwed together in a series chain, with the end members
having axial wires for soldering.
Wire Terminations: Styles D and KU. See illustration.
Material: Solder-coated copper wire.
Screw Terminations: Styles D and KU. See illustration.
Material: Turned brass.
Screw Thread: All caps are tapped UNF-10 x 4.2 deep. UNF-
10 is 32 TPI, 60° thread angle 4.72±0.07 mm outside diameter,
3.83 mm core diameter.
Coupling Stud: All KU & TU resistors are supplied with 8 mm
long screwed brass studs.
MARKING:
Type reference, resistance value, tolerance and data code are
legend marked.
SOLVENT RESISTANCE:
The lacquer and protective sleeve provide excellent resistance
to all normal industrial cleaning solvents suitable for printed
circuits.
General Note
IRC reserves the right to make changes in product specification without notice or liability.
All information is subject to IRC’s own data and is considered accurate at time of going to print.
Wire and Film Technologies Division • 4222 South Staples Street • Corpus Christi Texas 78411 USA
Telephone: [phone] • Facsimile: 361 992 3377 • Website: www.irctt.com
A subsidiary of
TT electronics plc
F Series Issue October 2008 Sheet 1 of 3